1) materials for water conservancy
填方材料
1.
In this paper,based on resources’ recycle,utilizing dredged spoils as materials for water conservancy is suggested.
从资源的再生利用出发,提出利用固化材料固化疏浚泥作为填方材料的设想,并通过强度试验、溶出试验等一系列试验证实,固化疏浚泥作为填方材料在技术经济指标上完全可行。
2) filling material
填充材料
1.
Selection of welding filling material formain transformer oil tank cover of type DJ_1 locomotives;
DJ_1型机车主变压器油箱盖焊接填充材料的选择
2.
The tungsten-inert-gas(TIG) welding test on YG30 cemented carbide and the 45# steel was done with Co-Fe-C alloys in different composition as filling materials.
选用不同成分Co-Fe-C合金作为填充材料,对YG30硬质合金与45钢进行了TIG焊试验。
3.
The filling material in EDI stack is introduced in this paper.
介绍了EDI膜堆填充材料的研究现状,认为离子交换树脂仍是今后填充材料的主要研究对象,离子交换纤维和其它新型填充材料的研究亟待有新的突破。
3) Filling material
充填材料
1.
Experimental study of anti-fracture strength in endontically treated teeth by different filling materials;
充填材料对牙齿抗折裂性能影响的实验研究
2.
The experiment studied the size distribution of filling material by U9(96) uniformity design method and found an excellent size composition.
作者采用U9(96)均匀设计方法对充填材料的颗粒级配确定进行了实验研究,确立了较优的颗粒组成,在此颗粒级配下,可使充填材料获得高的堆积密度和强度;在一定固相含量条件下,可使充填材料表观粘度明显降低,具有较好的工作性能。
3.
AIM: To compare the surface roughness of three dental filling materials.
目的:比较3种牙体充填材料的表面用在粗糙度。
4) filler
[英]['fɪlə(r)] [美]['fɪlɚ]
填充材料
1.
Effect of Ti filler on microstructure and properties of joint during TIG welding for aluminum matrix composite;
铝基材料TIG焊填充材料对接头组织性能的影响
2.
In this paper,the PTFE based composites were classified reasonably into several types according to the sorts of fillers.
根据填充材料的类别不同对聚四氟乙烯基复合材料进行了合理地分类,并阐述了不同填料对聚四氟乙烯基复合材料摩擦学特性的影响,分析和比较了不同填料的减摩抗磨机理,对于聚四氟乙烯基复合材料的科学研究和工程应用具有一定的借鉴和指导意义。
3.
The traditional filling process of cabtyre cables, which uses sheathing rubber, jute rope, rubber/polypropylene strips etc as filler, is ineffective with high cost.
在橡套软电缆的填充工艺中 ,通常的填充材料是采用护套橡皮、麻绳、橡皮条和聚丙烯索等 ,但填充效果及其经济性不理想 ,本文介绍用废胶料挤包细麻绳作填充条 ,其填充效果好 ,而且成本低 ,具有较高的经济效
5) backfill material
充填材料
1.
The newly testing and the applications of backfill materials, backfill geomechanics, paste backfill and backfill equipment are mainly introduce
综述了第七届国际充填采矿大会论文集的主要内容,着重介绍充填材料、充填体力学、膏体充填、充填设备与系统的应用现状与最新进展。
6) backfill materials
充填材料
1.
When curing time of rapid-hardening backfill materials is up to 60 days,the weathering of the materials will begin and at 90 days the weathering becomes more severe.
高水速凝固化胶结充填材料在养护至６０ｄ左右时，开始出现风化现象，到９０ｄ时较严重。
补充资料：填方
1.土木工程施工时填的土石方。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条