1) supply air temperature optimization
送风温度优化
1.
The strategies of supply air static pressure optimization and supply air temperature optimization are presented.
本文提出了变风量系统的送风静压和送风温度优化控制方法以及多区域新风量优化控制方法。
2) blast temperature
送风温度
1.
Representative instrument adjusting loop——the composition and characteristic of combustion control;blast temperature control;blasting humidity control are emphasized.
着重介绍了热风炉典型仪表控制回路——燃烧控制、送风温度控制、送风湿度控制的构成和特点。
2.
When no high heat value gas input,blast temperature of HBS is 1250～1300℃.
没有高发热量煤气混入时,热风炉送风温度为1250～1300℃；有高发热晕煤气混入时,热风炉送风温度为1350～1400℃。
3) supply air temperature
送风温度
1.
Modeling and control research of supply air temperature control systems in VAV air conditioning units;
变风量空调机组送风温度系统建模与控制研究
2.
Meanwhile, this paper also brought forward and analyzed the optimal control strategy of supply air temperature satisfying the relative humidity control requirement of ASHRAE Standard 62-2001.
在变风量空调及其控制系统动态仿真软件的基础上,根据ASHRAEStandard62-2001标准对于湿度控制的要求,分析了送风温度和冷媒水供水温度对空调区域相对湿度控制的影响。
3.
One is on line optimal reset of supply air temperature set point, which uses the signal of local controller of VAV damper as index of indoor relative load; another is on line optimal on/off control of CAV boxes which are designed for external zones because of solar heat gains.
其一是利用变风量末端风门开度的信号 ,将它们作为各区域相对负荷的指示信号 ,对送风温度进行实时优化 ;其二是针对周边区域采用定风量末端控制太阳辐射热负荷的空调系统 ,根据周边区域相对负荷大小 ,实时优化定风量末端的开 /停控制 。
4) air supply temperature
送风温度
1.
In order to obtian the regulation that air supply temperature influence on velocity field and contaminant concentration in the displacement ventilation room,this paper adopted computational fluid dynamatics software,and used two-equation turbulence model to simulate the flow field of different air supply temperature.
为得到送风温度对置换通风房间速度场及污染物浓度影响的规律,采用计算流体力学CFD软件,运用两方程湍流模型模拟不同送风温度下的房间流场。
5) delivery and return air temperature
送风及回风温度
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条