1) loading balance
加载平台
1.
Aircraft landing gear loads calibration test technique based on loading balance;
基于加载平台的起落架载荷地面校准技术研究
3) load of platform
平台压载
4) vehicle-borne platform
车载平台
1.
Research on a levelling control system for vehicle-borne platform based on CAN bus and PLC;
基于CAN总线和PLC的车载平台调平控制系统研究
2.
It is used to determine position and attitude of vehicle-borne platform.
GPS是3Dsurs系统中关键传感器之一,用于测量车载平台的位置和姿态角。
5) airborne platform
机载平台
1.
Combined with the character of the airborne platform,an infrared passive triangulating positioning method applying to a single aircraft was proposed.
研究了基于测角的被动定位方法,分析了双站测角定位系统的测距精度,针对双站测角定位精度较低且在一些目标方位上出现的几何方位影响精度(Geometric Dilution of Precision,GDOP)问题,结合机载平台的结构特点,提出了一种适用于单架飞机的红外被动测角定位方法。
2.
The MoM-UTD method is employed to analyze the frequency characteristic of isolation between antennas on airborne platform, however, it has large calculation amount and takes a long time, since the impedance matrix must be computed for each new frequency.
在用该方法分析机载平台上天线间隔离度的频率特性时,由于每一个频点都需要重新计算阻抗矩阵,因此分析整个频带内隔离度的计算量很大,耗时很长。
3.
Airborne platform is an electrically large object and it is difficult to analyze the isolation between antennas mounted on it only by using the Method of Moment (MoM).
天线间的隔离度是机载平台电磁兼容(EMC)的重要指标之一。
6) offload platform
卸载平台
1.
This paper built up a computational model of the collision avoidance system composed of berthing ship,rubber fender and offload platform.
建立了靠泊船舶、橡胶护舷和卸载平台组成的避碰系统的计算分析模型,利用能量法计算任意时刻的船速、橡胶护舷的反力和吸能以及船舶允许的最大靠泊法向速度。
补充资料：自动加载下载的*.dmt材质方法
自动加载下载的*.dmt材质方法一
1、建立如下路径的文件夹：
E:\graphiclib\graphic-library\
然后把你下载的adv_materials文件夹（里面材质了）放到刚才建立的路径里，变成如下路径
E:\graphiclib\graphic-library\adv_materials
2、如图配制搜索路径
3、这样调用！点PHOTOLUX材质库
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条