说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 瞬时蒸发
1)  Flash evaporation
瞬时蒸发
1.
According to low boil temperature of LPG,the flash evaporation model was applied to simulate spray and evaporation in LPG direct injection engine,and find the parameters of drop sizes,temperature,gas fuel vapor mass fraction and so on.
42软件平台下采用瞬时蒸发模型对LPG缸内直接喷射发动机喷射、雾化过程进行仿真,得到LPG缸内直接喷射的油滴尺寸、温度以及油滴的贯穿距等参数的特性。
2.
Polycrystalline Bi thin films with thickness in the range of 40~160 nm were successfully deposited on glass substrates at 453K by flash evaporation method.
瞬时蒸发法在加热到453K的玻璃基体上沉积出了厚度在40-160nm的多晶Bi纳米薄膜。
2)  instant-heat thin-film evaporator
瞬时薄膜蒸发器
3)  instant-heat thin-film evaporator
瞬时加热薄膜蒸发器
4)  flash evaporation
瞬间蒸发法
1.
5 thermoelectric thin films with thickness in the range 50-400nm have been deposited by flash evaporation method on glass substrates at 473K.
在玻璃衬底上通过瞬间蒸发法沉积了厚度为50-400nm的N型Bi2Te2。
5)  prompt explosion
瞬时爆发
1.
Effect of electron screening on the prompt explosion energy for type Ⅱ supernova;
电荷屏蔽对Ⅱ型超新星瞬时爆发能量的影响
2.
The supernova prompt explosion of a progenitor model Ws12M-⊙ is simulated.
对超新星前身星模型Ws12M⊙的瞬时爆发进行了数值模拟,讨论了压强梯度对超新星瞬时爆发能量的影响。
6)  Evaporation time
蒸发时间
1.
Effect of evaporation time on the structure and property of PES membrane formed by a dual-bath coagulation method;
蒸发时间对两级凝胶法制备的聚醚砜膜结构和性能的影响
2.
Recent research of the evaporation times of pesticide droplets on plant leaves both at home and abroad was introduced in this paper,including the way to establish droplet evaporation time testing system,the experiment design procedures,and the techniques for data analysis,in order to increase the efficiency of pesticide application.
而雾滴在叶面上蒸发时间的长短,会改变叶子对药液的吸收量和吸收速度,从而影响农药施用效率。
补充资料:RSCG01-5000管式超高温瞬时(UHT)杀菌机

应用:
应用于乳品、果汁或茶等流体物料,在管式热交换器中对物料进行超高温瞬时杀菌处理(UHT)。

工作原理:
该设备为全自动设备,其运行操作可以分为以下四个步骤:
1. 设备预杀菌
2. 物料杀菌
3. 无菌中间清洗
4. 最终清洗
     在正式生产前,设备在高压下进行30分钟的热水循环,以完成对设备物料通道的预杀菌处理,随后,将设备逐步冷却到生产温度,然后进入待料状态。
当下游设备(包装机、无菌罐等)准备就绪后,即可进行生产(物料杀菌)。
每个生产周期结束后,都要用碱液或酸液对系统进行清洗。
在设备的设计中采用了再生热交换技术,提高热传输效率,节约能源。

设备组成及技术指标:
由物料桶、输送泵、管式换热器、保持器、过热水系统、CIP清洗系统及控制系统等组成。
操作系统采用图象式人机对话操作界面,便于随时直观地掌握设备各组件的运行状态;控制系统对设备进行温度实时控制、采集和存储。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条