1) shape-location adjustment
形位调整
1.
The paper also presents the technologies of primitive relationship conversion and primitive shape-location adjustment to translate tangent relationship into scan and connected relations,to translate surface solid interceptive relationship into intersected relationship,and to adjust the shapes and locations for obtaining correct reconstruction results.
提出基元关系转换和基元形状位置调整技术,将相切关系转化为扫描和相接关系,将曲面立体截切关系转化为相交关系,为获得正确的重建结果,对相接、相交和截切关系进行形位调整。
2) Location Adjustment
位置调整
3) phase adjustment
相位调整
1.
The operating principle of interface circuit is analyzed and discussed,and the horizontal sync-phase adjustment circuit is designed and studied in de- tail.
同时,对行同步相位调整电路进行了详细的电路设计和研究。
2.
Amplitude and phase adjustment units are important parts in ground wave OTH-radar transmitter,implementing conversion and adjustment of HF detection signal.
文中给出了幅值调整控制器和相位调整控制器的数学模型,介绍了幅相调整单元的结构组成和信号流程,并在此基础上阐述了幅度控制系统和相位控制系统的工作原理。
3.
This paper introduces the frequency multiplication(the MLT04 Four-Channels、Four-Quadrant Analogy Multiplier) circuits and the phase adjustment circuits in the data processor with the Photoelectrical rotary encoder.
介绍光电轴角编码器的数据处理装置中乘法倍频电路 (模拟乘法器MLT0 4 )和相位调整电路的实现 ,实验证明 ,采用四象限模拟乘法器对精码信号乘法倍频 ,经过倍频后的信号斜率增大 ,整个细分周期内误差变小 ,倍频方法在理论上不含高次谐波 ,可以提高莫尔条纹的高倍软件细分的细分精度。
4) pulverized coal level adjustment
粉位调整
5) phase adjusting
相位调整
1.
Y→△transformation is conventionally used by CT secondary current phase adjusting of transformer differential protection while its sensitivity of single phase to earth fault is lower than that of three phase fault and interphase fault.
变压器差动保护电流相位调整通常采用Y→△变换 ,在单相故障时灵敏度低于相间短路与三相短路灵敏度。
6) Adjustment of displacement
位移调整
补充资料：Pro/Engineer Drawing 修改形位公差
菜单：DETAIL > modify > Geom Tol
选择一个形位公差，会出现上节中的对话框。按需要修改即可
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条