说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 非限定缺陷
1)  non-restrict disadvantages
非限定缺陷
1.
In this paper,an eigenvalue,which and correctly indicates the characteristics of heat transfer and energy-saving in building envelopes,is suggested by analyzing existed non-restrict disadvantages and some engineering problems for the overall heat transfer coefficient.
通过分析围护结构传热系数存在的非限定缺陷以及由此造成的工程问题,提出了一个基本能合理表征围护结构传热及节能特征的参量,即围护结构热阻,它完全避免了由外环境条件变化而引起的设计和检测中的不一致性问题。
2)  defect tolerance
缺陷容限
1.
The linear inner defect tolerances corresponding to the safety graduations are stipulated in " in use pressure vessel inspection stipulation",item 36,table 3.
《在用压力容器检验规程》第36款表3规定了相应安全等级的线性埋藏缺陷容限,本文运用《CVDA—84压力容器缺陷评定规范》,对其它一切条件不变而只有应力水平发生变化时相应安全等级的缺陷容限的变化量和变化规律作初步探讨,希望对表3从强制性规定转为指导性条款起一定的参考和促进作用。
3)  nondeficit type
非缺陷型
1.
Methods 90 schizophrenics were classified into deficit(n=27)and nondeficit type(n=63)by the Carpenter s Diagnostic Criterion for Deficit Syndrome,their pre-treatment serum prolactin levels were detected with the radio-immunization and differences of serum prolactin levels of same sex intertype compared,and compared with 30 healthy controls.
目的探讨缺陷型与非缺陷型精神分裂症患者血清催乳素水平的差异性。
4)  Non-defects wave
非缺陷波
5)  defect assessment
缺陷评定
1.
The fuzzy clustering method was introduced to ascentain mechanical properties of materials in defect assessment for pressure vessels.
采用模糊聚类方法 ,确定了在用压力容器缺陷评定中断裂韧度的代用数据 ,结果与试验数据相符 ,且与其它选用原则和确定方法的结果一致。
2.
It is suggested that the two equivalent loading methods could be used to calculate the fatigue life of structures loaded with variable amplitude loading in defect assessment.
作者建议两者都可以用于缺陷评定中变幅载荷下的疲劳寿命计
6)  Flaw discrimination
缺陷定性
补充资料:点缺陷(见晶体缺陷)


点缺陷(见晶体缺陷)
point defect

  点缺陷point defeet见晶体缺陷。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条