说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 综合测试仪
1)  integrated test instrument
综合测试仪
1.
Software and hardware design for TD-SCDMA integrated test instrument physical layer;
TD-SCDMA终端综合测试仪物理层的软硬件设计
2.
Based on specific requirements of TD-SCDMA integrated test instrument,solutions of its physical layer design were discussed at length,in which both hardware and software solution were detailed respectively.
针对 TD-SCDMA 终端综合测试仪功能特点,着重介绍了仪器物理层部分的软硬件设计。
2)  Integrated testing instrument
综合测试仪
1.
A kind of petrol engine integrated testing instrument based on LabVIEW was developed, which is composed of the igniting performance testing instrument, the power performance testing instrument, the starting performance testing instrument, the digital multimeter etc.
利用LabVIEW 虚拟仪器开发平台,进行了汽油发动机综合测试仪研制,该测试系统由点火性能测试仪、动力性能测试仪、起动性能测试仪、数据万用示波表等测试子模块组成,并通过实际测试对该系统进行了检验,测试结果较客观地反映了被测发动机的实际工作状况。
3)  all-purpose tester for vehicles
汽车综合测试仪
1.
The data processing function of the CTM-2002A all-purpose tester for vehicles is extended through software developing,thus improving the efficiency of the testing work of vehicles.
通过开发软件扩展CTM-2002A汽车综合测试仪的数据处理功能,提高了汽车测试工作的效率。
4)  intellectualized and integrated testing instrument
智能综合测试仪
5)  comprehensive flap tester
襟翼综合测试仪
1.
The method of Chinese character display based on the comprehensive flap tester;
襟翼综合测试仪的汉字显示
6)  Comprehensive ion testing instrument
离子综合测试仪
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条