1) redundant squeezing force
剩余压紧力
1.
The forces acting on a sliding boot,the key element of swash-plate axial piston pump,are analyzed and the formulas computing squeezing and repelling forces are derived;the redundant squeezing force method is presented,including the selection of parts materials,squeezing force factor and the determination of geometric parameters of a sliding boot.
分析了斜盘式轴向柱塞泵的关键摩擦副零件滑靴的受力,导出了压紧力和分离力的计算公式;介绍了滑靴设计方法中的剩余压紧力法,包括零件材料、压紧力系数的选择以及滑靴关键几何参数的确定。
2) overpressure
[英]['əuvə'preʃə] [美]['ovɚ'prɛʃɚ]
剩余压力
1.
Under 1 500 meters of ground,the compaction coefficient can be calculated by the half-log-arithm normal trend equation,and the overpressure can be calcu-lated according to the relation of interval transit time and forma-tion pressure.
东营凹陷南坡异常高压的分布与成藏关系密切,在1500m以下的埋深条件下,可以采用半对数式回归正常趋势线方程求取压实系数,再运用声波时差与地层压力的关系计算剩余压力。
4) remainder compressing coefficient
剩余压紧系数
1.
This paper pointed out that it was significant to borrow ideas from the current theory of pressure distribution regularity in port plate/cylinder block friction pair at home and abroad to determine the optimal remainder compressing coefficient.
指出需借鉴国外现有的关于轴向柱塞泵配流副压力分布规律的理论 ,确定最佳剩余压紧系数 ,现有的配流副结构设计方法和理论依据需进一步完善。
5) surplus pressure modulus
剩余压力系数
6) excess-pressure gradient
剩余压力梯度
1.
Relationship between excess-pressure gradient and gas accumulation in overpressured basin;
超压盆地内剩余压力梯度与天然气成藏的关系
补充资料:无弹性架压磁测力传感器压头
无弹性架压磁测力传感器压头
无弹性架压碰测力传感器压头
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条