1) aerated inception point
掺气位置
2) doping location
掺杂位置
1.
The influence of doping location of three small-molecule fluorescent dyes including dimethylquinacridone(DMQA),4-(Dicyanomethylene)-2-t-butyl-6-(1,1,7,7-tetramethyljulolidyl-9-enyl)-4Hpyran(DCJTB),5,6,11,12-tetraphenylnaphthacene(Rubrene)on the performance of organic light emitting diodes(OLEDs)has been systematically investigated.
利用3种有机小分子荧光染料dimethylquinacridone(DMQA),4-(dicyanomethylene)-2-t-butyl-6-(1,1,7,7-tetramethyljulolidyl-9-enyl)-4Hpyran(DCJTB)和5,6,11,12-tetraphenylnaphthacene(Rubrene)作为掺杂剂,研究了其掺杂位置对于有机电致发光器件(OLED)性能的影响。
3) pre-aerator
前置掺气坎
1.
The hydraulic characteristics of the smooth spillway,the stepped spillway and the pre-aerator stepped spillway have been studied respectively.
对光滑溢洪道、阶梯溢洪道和前置掺气坎式阶梯溢洪道水力特性进行了对比研究。
4) A-site compound doping
A位置复合掺杂
1.
Influence of A-site compound doping on chemical diffusion coefficient of perovskite oxides(La_(1-x)Pr_x)_(2/3)Sr_(1/3)Co_(0.8)Ni_(0.2)O_3
A位置复合掺杂对钙钛矿氧化物(La_(1-x)Pr_x)_(2/3)Sr_(1/3)Co_(0.8)Ni_(0.2)O_3化学扩散系数的影响
5) gas inlet position
进气位置
1.
The influence of gas inlet position on the distribution of gas along filter axis and configuration of dust layer was investigated.
对进气位置对陶瓷过滤器对气流分布和粉尘层结构的影响进行了试验研究。
6) aerating position
充气位置
1.
In an aerated spouted bed with a draft tube made of polymethylmethacrylate with internal diameter 92 mm, the glass beads used as experimental material, under the different aerating velocity, aerating position, punching rate, the bed pressure drop and particles down moving rate in the annulus were studied.
在直径 92mm的有机玻璃制的带导向管的充气喷动床中 ,以玻璃珠为实验物料 ,在不同的充气量、不同充气位置、导向管不同开孔率条件下 ,对充气喷动床的床层压降和颗粒在环形区的下移速度进行研究 。
补充资料：掺掺
1.女手纤美貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条