1)  capacitance performance
容量特性
2)  capacitance properties
电容量特性
3)  mass property
大容量特性
4)  Power
容量
1.
Analysis of Safety and Economy of Power Selection of Distribution Transformer in Substation;
变电所用配电变压器容量选择的安全经济分析
2.
Transformer Power Choice and Economical Operation;
变压器的容量选择与经济运行
3.
It disusses the main problems about selecting new types of lower loss power transformer,such as the relationship between the loss and standard series、operating cost,the relationship between the capacity selection and service life loss calculation etc.
论述了新型低损耗电力变压器的选用中容易遇到的主要问题 ,如损耗与标准系列、运行成本问题、容量选择与变压器寿命损失计算问题等 ,充分考虑变压器运行弹性及实际负荷曲线 ,选择最佳性能价格比的产品。
5)  Capacitance
容量
1.
Effect of Doping Ions on Electrochemical Capacitance Properties of Polypyrrole Films;
掺杂离子对聚吡咯膜的电化学容量性能的影响
2.
Capacitance Properties of Porous Polypyrrole Thick Films Prepared Electrochemically by Multi-step Polymerization;
多次聚合法制备多孔聚吡咯厚膜及其电化学容量性能
3.
Forecasting of cell capacitance based on grey theory;
基于灰色理论的蓄电池容量预测
6)  volume
容量
1.
Effects of different ratios of concentration and volume of bupivacaine and fentanyl on postoperative epidural analgesia;
布比卡因和芬太尼浓度与容量匹配对肝脏术后硬膜外镇痛效应的影响
2.
Ultrasonic Observation and Research on Normal Citizen s Left Atria s Internal Diameter and Volume;
正常人左心房内径容量的超声观测研究
3.
Clinical observation on interscalene brachial plexus block with ropivacaine of two different volumes;
两种不同容量罗哌卡因用于肌间沟臂丛神经阻滞的临床观察
参考词条
补充资料:BET容量法
分子式:
CAS号:

性质:利用BET理论测定吸附量和计算固体化表面积的经典方法。其基本原理是,在精确测量过体积的真空体系中(包括泡形气体量管、死空间、连接部分的空间体积)放置一定质量的样品,引入一定何种的吸附质气体在恒温下达到吸附平衡后,根据因吸附作用而引起的压力变化计算在该平衡压力下的吸附量,是一个吸附点。依次改变泡形气体量管中气体体积,测量不同平衡压力下的吸附量,得若干个吸附点,从而根据BET公式计算比表面积。容量法是公认的测量固体比表面积的标准方法,测定值准确可靠。早期的玻璃仪器需对各部分体积精确测定,现已有成套自动装置,使用更为方便。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。