1) hot spot stress range
热点应力幅
1.
S-N curves based on the hot spot stress range are generally used to predict the fatigue life of tubular joints in offshore platformeering.
对海洋平台中圆管节点的疲劳寿命估算,通常采用的是基于热点应力幅基础上的S-N曲线法。
2) hot spot stress
热点应力
1.
Key influence factors in hot spot stress FEM analysis;
热点应力有限元分析的主要影响因素
2.
Weld seam fatigue analysis of locomotive damper hold by hot spot stress method;
机车减振器座焊缝疲劳的热点应力分析
3.
Study of fatigue strength assessment of welds based on hot spot stress;
基于热点应力的焊缝疲劳强度评定研究
3) hot spot stress approach
热点应力法
1.
The midship region cargo was modeled with shell and beam elements and a fatigue assessment was carried out with applying the hot spot stress approach as following the instructions of Common Structural Rules for Oil Tankers(JTP).
基于共同规范(JTP)的相关规定,针对某油轮建立三舱段有限元模型,采用热点应力法对内底和边舱斜板之间折角处进行了疲劳评估。
4) hot spot stress method
热点应力法
1.
According to the Guide for Building and Classing Membrane Tank LNG Vessels of ABS,the finite element model had been built and the fatigue strength assessment of a LNG vessel had been carried out with nominal stress method and hot spot stress method based on the fatigue accumulating damage concept of S-N curve approach.
以某LNG船为研究对象,建立三舱段有限元模型,并根据美国船级社薄膜型LNG船体结构疲劳强度指南,基于S-N曲线法的疲劳积累损伤原理,分别采用名义应力和热点应力法,对船体典型节点进行疲劳强度评估,同时对计算结果进行分析;讨论低温下材料性能改变对节点疲劳寿命评估的影响。
5) hot spot stress areas
热点应力区
1.
The stress distribution of tubular T-joints at hot spot stress areas and its maximum stress concentration factors(SCFs)under the axial loads are analyzed by use of finite element method.
用有限元方法分析了承受轴向拉力作用时T型管节点在热点应力区的应力分布,以及最大应力集中系数,通过计算发现,最大应力集中系数出现在鞍点处。
6) SPATE(stess pattern analysis through thermal emissions)
热幅射应力模型分析
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条