1) apparent frictional resistance
表观摩擦阻力
1.
Test results show that the quantity of apparent frictional resistance between g.
通过室内拉拔试验研究了不同含水率条件下经编土工格栅与土体间的界面作用特性,试验结果表明:在相同的法向应力下,土工格栅被拔出破坏时对应的极限表观摩擦阻力随着土体含水率的增加而降低;不论土工格栅是整体被拔出破坏还是纵肋被拔出破坏,土工格栅和土体界面间的表观摩擦角和表观粘着力均随着土体含水率的增加而降低;土工格栅与土体界面间的破坏形式由土工格栅的整体被拔出破坏转变为纵肋被拔出破坏时对应的法向应力随着土体含水率的增加而增大。
2.
Pullout test results show that the quantity of apparent frictional resistance between two-way geogrids and clay increases with the normal stress increasing.
室内拉拔试验结果表明,双向土工格栅与黏土界面的表观摩擦阻力随法向应力的增加而增加;在较低的法向应力作用下,双向土工格栅与黏土界面间的破坏形式为土工格栅的整体拔出破坏;当法向应力增加到一定值后,双向土工格栅与黏土界面间的破坏形式由土工格栅的整体拔出破坏转变为土工格栅的纵肋拔出破坏;双向土工格栅整体拔出破坏时,表观黏着力小于纵肋拔出破坏时的表观黏着力,而表观摩擦角则相反。
2) skin friction resistance
表面摩擦阻力
3) virtual friction
表观摩擦
4) Frictional Resistance
摩擦阻力
1.
Influence of the frictional resistance for deadline anchor axis on weight indicator accuracy;
死绳固定器轴上摩擦阻力对指重表精度的影响
2.
Influences of frictional resistance on flow distributions of the dividing and combining manifolds;
摩擦阻力对分流和汇流联箱流量特性影响
3.
A method for lateral buckling analysis of tubing with frictional resistance in deviated wells was presented.
提出了在斜直井中钻柱正弦屈曲分析时对摩擦阻力的处理方法,给出了考虑摩擦阻力时的屈曲平衡方程,建立了相应的微分求积法列式,用微分求积法时平衡方程直接求解。
5) Friction resistance
摩擦阻力
1.
An experimental investigation on the flow and heat transfer of the narrow-gap annular tube vapor generators.Ⅱ.Friction Resistance.;
窄缝环形管内流动与传热实验研究 Ⅱ.摩擦阻力特性
2.
Based on the analysis of macrostructure and microstructure of the sample after ECAE, the influence of friction resistance between the die wall and the sample on the deformation of the sample billet was discussed.
通过对挤压后纯铝试样的宏观变形及微观形貌分析,探讨了ECAE过程中模具内壁与试样之间的摩擦阻力对试样变形的影响,得到了滞变区比例与挤压位移之间的关系。
3.
In daily mine ventilation work,we treat as airway friction resistance factor a constant.
在矿井通风业务实际计算中认为 :对于某特定巷道的摩擦阻力系数视为一定值 ,不考虑其随风流流向改变而改变。
6) friction force
摩擦阻力
1.
In this paper,the effect of friction force on metal forming parameters has been summarized based on some last research reports.
论文基于近期已发表的文献 ,综述了摩擦阻力对金属成形参数的影响。
2.
The paper introduces the method and principle of testing friction force between mould plates and strand on the slab caster.
介绍了板坯连铸机结晶器铜板与铸坯摩擦阻力的测试原理和方法，分析了铜板与铸坯之间的摩擦状态与摩擦阻
3.
What s more,the produced friction force and the added moment,which act on the transmission shaft,influence equipment performance and increase equipment load.
通过对齿轮联轴器工作时的运动和受力分析得知,当补偿轴向位移、径向位移和角偏差时,在接触齿面之间存在滑动摩擦,滑动速度较大,使齿轮联轴器容易磨损破坏;并且在传动轴上产生摩擦阻力和附加弯矩,影响设备性能,增大设备负荷。
补充资料：摩擦阻力
分子式：
分子量：
CAS号：
性质：见流体阻力。
分子量：
CAS号：
性质：见流体阻力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条