1) settlement observation result
沉降观测结果
1.
The karst geological condition,the design and construction,and the settlement observation result of the low-grade plain concrete pile composite foundation for the Longgang Culture Center in Shenzh.
介绍了深圳市龙岗文化中心的岩溶地质条件、复合地基设计和施工情况;沉降观测结果表明,在岩溶地区使用素混凝土桩复合地基技术是可行的。
2) settlement observation
沉降观测
1.
Technologies for Wuhan-Guangzhou railway passenger dedicated line settlement observation and prediction of settlement deformation;
武广铁路客运专线沉降观测与预测技术
2.
On settlement observation and analysis of one high-rise commercial and living building in Shaoxing;
浅谈绍兴某高层商住楼建筑沉降观测及分析
3.
Construction and settlement observation of large pile foundation;
大型桩基础施工及其沉降观测
3) subsidence observation
沉降观测
1.
Practice of the subsidence observation on the industry squarein Panyi Coal Mine;
潘一矿工业广场沉降观测实践
2.
Superficial discusses about subsidence observation of the highrise building;
浅谈高层建筑物沉降观测
3.
But because of hard to fix test ring in bedrock, so report of domestic deep worked-out area overlying rock subsidence observation by layers have not yet been heard so far.
研究采空区剩余沉降对上覆建(构)筑物造成的危害程度,分层沉降观测是比较直观的方法,但由于基岩内测试环固定困难,在大深度采空区上覆岩层中进行分层沉降观测国内未见报道。
4) sedimentation observation
沉降观测
1.
Application of DiNi 12 electronic level in sedimentation observation;
DiNi 12电子水准仪在沉降观测中的应用
2.
The article introduces the soft roadbed treatment of Guangdong Xintai Highway connections,overloads pre-pressure on soft roadbed segment,sedimentation observation,datum calculation,analysis and estimation,and discusses effect of soft roadbed treatment project.
文章介绍广东新台高速公路司前连接线软土路基处理、软基地段超载预压、沉降观测、数据计算、分析与评价,探讨软土路基处理工程的影响。
3.
Combining with two skyscrapers building on the mountain foot with pile foundation to be wrapped up with soft material for hot insulation and heat preservation afterwards,this paper discuses the sedimentation observation and the data process and analysis methods.
结合两幢位于山坡且楼体外有隔热保温敷层的桩基高层住宅楼施工测量,探讨了桩基高层建筑施工中的沉降测量及数据处理分析方法;对沉降观测中需要特别注意的若干问题进行了分析探讨,特别指出了:相对于普通的沉降测量,由于某些桩基可能受到上拔力的作用,基准点的稳定性更重要,其布设应更科学慎重;一些不依赖于基准点的数据处理和分析方法可能会导致错误的分析结果。
5) settlement measurement
沉降观测
1.
According to the static loading test of DJM pile compound foundation and the settlement measurement test,the DJM pile have been studied concerning foundation bearing capacity and stress ratio and have been analysized the bearing performances of the DJM pile composite foundation,thus theoretical basis and reference for DJM technique in pile engineering application.
根据粉喷桩复合地基的静载荷及沉降观测试验资料,对粉喷桩在地基处理中的地基承载力、桩土应力比等进行了研究,并对粉喷桩复合地基承载特性进行了简要分析,为粉喷桩的工程应用提供有益的理论依据和参考。
2.
In this paper,in combination with practice of penstock anchorage extra-large height difference settlement measurement for a pump-storage hydropower station,the measurement systematic error(including the invar leveling staff temperatare correction,scaled plane bend correction and circld bulb inclination correction)is analyzed.
结合某抽水蓄能电站镇墩特大高差沉降观测的实际工作,分析了铟钢水准尺温度改正、分划面弯曲改正及水准尺圆水准气泡倾斜改正等系统误差的规律,得出了一些有益的结论。
6) Subsidence Monitoring
沉降观测
1.
In this paper method of point selecting,surveying frequency and method of surveying of(filled body)subsidence monitoring of Sanming civilian use airdrome are introduced.
介绍了三明民用机场填筑体沉降观测的布点方案、观测频度、观测方法,论述了采用一元线性回归分析的方法拟合沉降模型,处理沉降数据,计算剩余沉降量和最终沉降量。
2.
The setting up of point as the base of bench mark in subsidence monitoring, the selection of observing point for subsidence monitoring, the observing period and the observing processes in fields are introduced in this paper; and according to practical project, using Microsoft Excel2003 to deal with data and generate curve chart of time-subsidence.
对沉降观测水准基点埋设、沉降观测点布设、观测周期及野外观测程序作出简要阐述,结合具体工程利用Microsoft Excel 2003对数据整理并绘制时间—沉降量关系曲线图。
补充资料：测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d，时，取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。，为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac，ptability of test，ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见，当得到一个测试结果时，所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以，对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查，实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的，均可接受。比如，在重复性条件下，所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值，则认为两个结果是一致的，均可接受;如果两个侧试结果的绝对差超过r，则认为它们是不一致的，必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989)，在重复性条件下，如果两个测试结果的绝对差不超过r的值，可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值，并且测试费用较低，须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c，瓜(4)二3.6a，时，取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值，并且测试费用较高时，只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条