1) design thickness
设计厚度
1.
In this article,the fact that the difference existed between the design thickness of the vessel fabricated by stainless steel clad plate and the final thickness of the product may result in severe consequence was indicated.
说明了不锈钢复合钢板制造压力容器的设计厚度与制造成品的最终厚度之间的差异,及可能造成不满足设计要求的严重后果,提出了设计制造应注意的问题。
2) thickness design
厚度设计
1.
The head thickness design of the semi-armor piercing warhead is calculated and analyzed applying the Dimen- sional-Analysis and Similitude-Law as well by the experiment data gained in the cylinder bumping experiment,the rela- tionship curve between the length of the distorted part and its velocity is gained that can be as one of bases while desig- ning the semi-armor piercing warhead.
结合所获得的实验数据,应用因次分析和相似律的方法对半穿甲战斗部顶部厚度设计进行了计算与分析,得到变形部分长度与速度的关系曲线,可以作为半穿甲战斗部顶部厚度设计的依据之一。
3) Pavement design thickness
路面设计厚度
4) design throat thickness
焊缝设计厚度
5) shaft lining thickness design
井壁厚度设计
6) Design Wall Thickness
设计壁厚
补充资料：1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
叠 135Omm双流板坯连铸机(重庆钢铁设计研究院设计)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条