1) furnace size
炉膛尺寸
2) selection of furnace dimensions
炉膛尺寸选择
3) furnace core size
炉芯尺寸
4) full-scale boiler
全尺寸锅炉
5) furnace geometry
加热炉几何尺寸
1.
The withdrawal rate and furnace geometry were considered in this model,and the temperature distributions during directional solidification process at two different withdrawal rates were investigated.
模型中考虑了抽拉速度、加热炉几何尺寸等影响,研究了2种抽拉速度下的温度分布。
6) furnace hearth
炉膛
1.
Through the production practice, reasons to deflagration of the furnace hearth of the heating furnace were analyzed, and the different circumstances of the explosion to prevent the measures and methods were put forward.
结合生产实践,对加热炉炉膛爆燃的原因进行了分析,并针对不同情况提出了防止爆燃的措施和方法,确保加热炉安全运行。
2.
The relationship of furnace hearth height to productivity is analyzed,and the the principle and calculating method for determining furnace hearth,are given.
论述了炉膛高度对加热炉生产的重要性和确定炉膛高度的原则 ,给出了确定炉膛高度的计算方法。
3.
On the basis of the result of that temperature is measured on three levels mesh belt type of far infrared dry stove during experimental production,This essay has preliminarily approached temperature distribution's condition in fumace hearth of far infrared heater and method of reducing temperature differential of the furnace heart
本文依据对多层网带式远红外干燥炉的试生产测试结果，对远红外加热炉炉膛内的温度分布态势及缩小温差的措施，作初步探讨。
补充资料：工程图标准尺寸及坐标尺寸
标准标注类型，是我们常用的标注类型。而坐标标注是便于数控加工采用的另一中标注形式。PRO/E可以将两种标注方式进行转换。
· 3.2 标准标注到坐标标注的转换
注意： 转化为坐标标注的尺寸必须是线性标注的，下列尺寸不能转化为坐标标注：
- 被显示成线性尺寸的直径
- 中心线尺寸
- 选择MODIFY DRAW > Dim Params > Dim Type > Ordinate Dim > Create Base.
- 选择作为参考基准线的尺寸
- 选择基准的引出线，该点为0点
- 选择 MOD DIM TYPE > Lin to Ord .
- 选择线性尺寸：注意：必须选择具有相同基准的尺寸
========>>>>
1. 选择 DIM PARAMS > Diam Dim Type .
2.点击Ord to Lin 
3.选择尺寸即可
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条