1) Straightening
校直定尺
2) straightening
校直
1.
The key problems and its research development trends of shaft parts' automatic cold straightening technology theory;
轴类零件自动校直技术现状及发展趋势
2.
Theoretical and experimental research on straightening technology based on rolling optimization;
基于滚动优化的校直工艺理论及实验研究
3.
Research on stroke-algorithm of shaft-straightening;
轴类零件精密校直行程算法研究
3) alignment
校直
1.
This paper deals with the basic principle in alignment of axis parts base on the spatial geometry theory and axis deformation formulation theory.
由于在实际生产中压下某一弯曲位置会对其他弯曲位置有很大的影响,造成反复多次下压,影响工作效率,从而不能适应大批量生产的要求,也不能满足对校直精度越来越高的要求。
2.
This paper begins with an analysis of thereasons and diagnosis examples of the bending of bend axis in the diesel engine, and then expounds the test and alignment process of the bend axis and in the simple and crude case.
本文阐述了柴油机曲轴弯曲的成因及曲轴弯曲分析诊断事例 ,详细叙述在条件简陋的情况下检测曲轴弯曲及校直的过程。
4) straightening wheel
校直轮
5) straightening stroke
校直行程
1.
Based on that,a method of establishing a high precise interpolation table between the initial deflection(δ0) and straightening stroke(δ∑) is put forward for the determine of the straightening stroke of a automatic precise straightener,and a MATLAB program for the straighten-ing stroke's calculati.
在此基础上,提出通过建立高精度的初始挠度(δ0)与校直行程(δ∑)对应数值插值表的方法解决自动精密校直机校直行程的确定,进而编制了常见截面工件校直行程计算MATLAB程序。
2.
Three calculation methods of straightening stroke are generalized and analyzed.
文中明确了压力校直的含义,阐述了压力校直工艺的主要参数,分析总结了三种校直行程的计算方法。
6) straightening machine
校直机
1.
The simulation and application study on the hydraulic press servo system based on high precision fuzzy control arithmetic in straightening machine;
基于高精度Fuzzy控制算法的校直机液压伺服系统的仿真与应用研究
2.
Compound drum straightening machine and its application;
复合转鼓式校直机及其应用
3.
A straightening machine controller based on embedded technology is introduced in this paper.
本文介绍了基于嵌入式技术的自动校直机控制器的设计。
参考词条
补充资料：校定
1.考核订正。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。