1) remained gas
残余气
2) Residual Pores
残余气孔
3) residual gas
残余气氛
1.
The effect of titanium oxide on the Ti coating on residual gas adsorption was studied.
最后分析了TiO2对铀表面钛膜吸附残余气氛的影响。
4) remained gas pool
残余气藏
5) Residual gas
残余气体
1.
An improved model of capacitive abosolute pressure sensors is presented based on the model for pressure-sensing membrane of pressure sensor,and the effect of the sensor performance due to residual gas in the sealed cavities when temperature changes is considered.
在传感器敏感膜模型的基础上对电容式绝对压力传感器提出了一种改进模型,考虑了由于温度的变化电容结构空腔中残余气体对传感器性能产生的影响。
2.
The influence of illumination intensity and residual gases on the stability of negative electron affinity GaAs(Cs,O) photocathodes during operation was investigated in the present work.
研究了光照强度和残余气体对阴极稳定性的影响 ,比较阴极在管壳内和激活室内的阴极稳定性 ,用俄歇谱仪分析激活的 Ga As光电阴极表面和灵敏度衰减到 0时的 Ga As光电阴极表面 。
6) residual porosity
残余气孔率
1.
SiC/Al composites were fabricated by pressureless infiltration technique, based on infiltration dynamics mechanism and technic method ,the effects of holding time and cooling way on the residual porosity of composites were discussed.
采用无压浸渗法制备了SiC/Al复合材料,从浸渗动力学和工艺方法的角度探讨了浸渗保温时间和降温方式对复合材料的残余气孔率的影响。
2.
Through analyzing the fracture microstructure, measuring line-shrinkage rate, density and residual porosity of sintered sample, the influence of sintering temperature on density and the influence of the type of dispersant on residual porosity of sintered sample were studied.
通过对烧结体断面显微结构的分析,以及对烧结体的线收缩率、密度和残余气孔率的测定,研究了烧结温度对坯体烧结致密化性能的影响和分散剂种类对烧结体残余气孔率的影响。
参考词条
补充资料：采气工艺(见天然气开采工艺)
采气工艺(见天然气开采工艺)
gas production technology
，一‘J\匕乙吕天然气开采工艺pro以uetionteehnology)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。