1) anodic current efficiency
阳极电流效率
2) the fall rate of anode current
阳极电流下降率
1.
The influence of the fall rate of anode current and snubber resistor on anode spike voltage was emphatically analyzed, on the basis of the relation between anode spine voltage and outer chat parameters, and ample experimental verification is given in this paper.
本文在GTO尖峰电压与外电路各参数关系的基础上，分别着重分析了阳极电流下降率和缓冲电路电阻对尖峰电压的影响，并给予了无分的实验验证。
3) plate efficiency
阳极效率
4) cathodic current efficiency
阴极电流效率
1.
Calculating cathodic current efficiency based on the by-products in electrolysis;
通过电解副产物计算阴极电流效率
2.
Effect of hydrogen inhibitor on cathodic current efficiency of zinc-iron alloy electrodeposition;
抑氢剂对锌-铁合金电镀阴极电流效率的影响
3.
The influence of L-ascorbic acid concentration and plating variables(bath pH value and temperature) on cathodic current efficiency has also been investigated.
研究了抗坏血酸质量浓度和pH对镀液稳定性的影响及抗坏血酸质量浓度、pH和温度对阴极电流效率的影响进行了分析。
5) anode current
阳极电流
1.
Way of analyzing anode current state of thyristor;
分析晶闸管阳极电流动态的方法
2.
Experiments point out: the neutron yield and its stability of a MTZ-54 neutron tube come to their top when the anode current of the tube is within a certain region;and the filament voltage/current need to be decreased gradually for keeping anode current stable while environmental temperature increases gradually.
实验发现,当MTZ-54型中子管离子源阳极电流处在某一区间内时,中子产额最高且最稳定;随着环境温度的升高,保持阳极电流稳定所需要的灯丝电压和电流需逐渐减小。
6) anodic current
阳极电流
1.
Particularly, the influence of electropolymerization conditions, such assupporting electrolyte solution composition, anodic current value and applied mode, on the capacitance and dissipation factor of as-made capacitor has been discu.
研究了导电聚吡咯在多孔Ta/Ta2 O5阳极体 ( 1μF/ 16V)表面的制备方法 ,采用恒电流电聚合法在该阳极体表面沉积一层导电聚吡咯作为电解电容器的阴极 ,着重探讨了支撑电解液的组成、阳极电流的大小及其施加方式对所形成的电容器容量和损耗因子的影响 。
补充资料：阳极效率
分子式：
分子量：
CAS号：
性质：见电流效率。
分子量：
CAS号：
性质：见电流效率。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条