1) Bug of the terminals
端部缺陷
2) plate defects
端面缺陷
1.
Three factors namely,propagation loss,plate defects and temperature variation,which(affect) the performance of the lithium niobate waveguide F-P filter are analyzed and discussed theoretically.
分析了影响LiNbO3波导型F P滤波器性能的3个因素:传输损耗、端面缺陷、温度变化。
3) interior defects
内部缺陷
1.
A research on solidified structure and interior defects of quasi rimmed steel dillet in the continuous casting;
准沸腾钢连铸坯的凝固组织和内部缺陷
2.
The influences of the different division of cross section reduced ratio on the interior defects have been researched with two work steps as the same total reduction.
结果表明,两次轧制成形增加了轧件内部产生空心缺陷的危险性,损伤量的大小随变形量分配的改变不同,可以通过合理的变形量分配以避免内部缺陷的产生。
5) inner micro-defect
芯部缺陷
1.
A finite element model for drawing process of high carbon wire with inner micro-defects was built.
对于相同尺寸的裂纹,J积分值随着模具顶角的增大而增加;当模具顶角小于8°后,J积分值变化较小,趋于一定值;J积分值随着摩擦系数的增大而增大;芯部缺陷的临界尺寸为30~40μm。
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条