1) inner recirculation
内混式
1.
Experimental study on shooting self-priming device of self-priming centrifugal pump with inner recirculation;
内混式自吸离心泵射流自吸装置的试验研究
2.
Aim at 5 inner recirculation self-priming centrifugal pumps that specific speed are 74~112,adopt 3 different inner-diameter suction pipes and 6 kinds of separation tongue gap,a more overall experimental study on self-priming time under rule height and the max vacuum that can be attained was carry on.
针对比转速为74~112的5台内混式自吸离心泵,采用3种不同直径吸水管和6种不同隔舌间隙,对其规定高度自吸时间和极限真空度进行了较全面的试验研究,并对试验结果进行了综合分析。
2) internal-mixing-oil-nozzle
内混式喷嘴
1.
In internal-mixing-oil-nozzle running state,when oil working-pressure higher than the certain atomizing-gas pressure,the pressure in the mixing chamber may be higher than the atomizing-gas pressure and the first critical-point working-state occurred that some part of oil flew backwards into the gas-pipeline system by the air holes.
对某内混式喷嘴采用冷态流量实验研究与数据处理相结合的方法,确定了这两类临界工况,为内混式喷嘴的可靠运行提供了依据。
3) internal-mixing nozzle
内混式喷嘴
1.
In flux calculation on internal-mixing nozzle,the pressure in the mixing chamber was often regarded as the production of atomizing medium pressure and critical compression ratio of this atomizing medium,but it has large error to the experimental result.
研究结果表明,内混式喷嘴混合室内压力并不等于雾化介质进口压力与临界压比之积,而与喷嘴的结构特性及运行参数密切相关。
2.
Experimental study on flux characteristic of internal-mixing nozzle;
实验结果表明,不同内混式喷嘴或同一喷嘴在不同运行参数下的流量系数值变化很大,与通常设计计算时的推荐值偏差最大达100%以上。
4) Inside mixed airless spraying
无气内混式喷涂
5) Interior composite-rotor
内置混合式转子
1.
Through the experiments on the static magnetic circuit device that simulates the magnetic circuit working mechanism of the interior composite-rotor controllable-flux permanent magnet synchronous machine,the laws of action spot change of NbFeB and AlNiCo PMs in the process of magnetization and after magnetization were studied,and the principle of the permanent magnet controllable-flux was revealed.
通过对模拟内置混合式转子可控磁通永磁同步电机磁路工作机理静止磁路装置的试验,认知了两种永磁体磁化过程和磁化后工作点的变化规律,揭示了磁通可控原理。
2.
A new kind of flux-controllable permanent magnet synchronous machine (PMSM) with interior composite-rotor structure was proposed.
提出一种转子内同时放置钕铁硼和铝镍钴两种永磁体的内置混合式转子磁路结构的可控磁通永磁同步电机。
6) interal mixing atomizer with high pressure
内混式高压喷嘴
补充资料：内卸式斗式提升机
分子式：
CAS号：
性质：斗式提升机的一种。该机用来连续、平稳输送粒度相对较小的能自由流动的物料。料斗固定在两根钢制滚子链上、设有能自动调整料斗和链条可移动的导向装置。料斗为环形向内开口。物料通过下部机壳内的斜槽送入。卸料则采用重力式。装料口和卸料口都是沿封闭循环料斗的内侧。卸料在提升机上部机壳经溜槽卸出。此机在低速条件下运行。
CAS号：
性质：斗式提升机的一种。该机用来连续、平稳输送粒度相对较小的能自由流动的物料。料斗固定在两根钢制滚子链上、设有能自动调整料斗和链条可移动的导向装置。料斗为环形向内开口。物料通过下部机壳内的斜槽送入。卸料则采用重力式。装料口和卸料口都是沿封闭循环料斗的内侧。卸料在提升机上部机壳经溜槽卸出。此机在低速条件下运行。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条