1) iterative compensation
迭代补偿
1.
The classical Preisach model for the hysteresis of GMA is introduced briefly, and a novel iterative compensation algorithm is proposed to avoid calculating Preisach converse model directly.
分析了异圆销孔的镗削加工特点,在迭代补偿的基础上设计了重复控制补偿器,并结合两种补偿方法,给出了一种基于复合前馈补偿的PID控制方法,最后通过实验检验了方法的有效性。
2) compensating iterative
补偿迭代
1.
(3) The compensating iterative method is more efficient than the Gauss-Sei.
分析了Horn-Schunk方法在运动边界处,光流场不能很好地保持不连续性的原因,并从3个方面对Horn-Schunk迭代模型作了改进:(1)在能量方程中用可变的权值系数代替原来的常权值系数;(2)采用一种新方法求解迭代方程中的速度均值,新方法体现了邻域的亮度差别对速度扩散的影响;(3)引入补偿迭代方法去求解相关的Euler-Lagrange方程,实验证明这种迭代方法比Gauss-Seidel方法更加有效。
3) iteration compensation
迭代补偿法
4) iterative compensation control
迭代补偿控制
1.
A closed loop controller based on inverse kinematics is used to control the simulator,and an open loop iterative compensation controller based on forward kinematics is developed at the same time to correct the posture driving signal and make simulator\'s response approximate the posture command gradually.
该试验台利用运动学反解算法进行闭环控制,并采用基于运动学正解的开环迭代补偿控制算法修正姿态驱动信号,使试验台的响应逐渐逼近期望的姿态指令。
6) error-comp iterative algorithm
误差补偿迭代算法
1.
The technique of momentum item which comes from improved strategy of BP(back propagation) artificial neural networks was introduced into load distribution for tandem hot strip rolling,and then a new iterative algorithm named error-comp iterative algorithm was put forward,its derivation process was introduced,the rationality of algorithm was analyzed.
将源于BP人工神经网络改进策略的动量项技术引入到带钢热连轧负荷分配中来,提出了误差补偿迭代算法,介绍了该算法的推导过程,并对算法的合理性进行了分析。
补充资料：层层迭迭
1.见"层层迭迭"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条