1) prearrangement of deformation amount
预留变形
1.
After a detailed analysis on the structure of an automotive bumper,a die was developed in which the CAE technology,some measures such as prearrangement of deformation amount,feasible sprue gate and two-way core-pulling mechanism were adopted to meet the requirements for the appearance and fit precision of the plastic component.
通过对塑件结构进行详细分析,利用CAE技术,采取了预留变形、合理浇口及双向运动抽芯等措施,保证了塑件的外观要求和配合精度;同时对模具结构进行了分析,结构合理,生产的塑件符合质量要求。
2) preset deformation
预留变形量
1.
In soft ground tunneling,the deformation of each cross-section differs very much,which causes great difficulties to the determination of the preset deformation.
在软弱围岩中开挖隧道,各断面变形值差异很大,这给预留变形量的确定造成很大困难;按预留变形量加工的钢架,难以与随时变化的断面形式及设计要求的轴线相吻合。
3) counter-camber
预留弯度，预变形，反变形
4) propositional obligate deformation
预留变形空间建议值
1.
Through numerical simulation by ANSYS/LS-DYNA, the propositional obligate deformation is 1.
通过ANSYS/LS-DYNA数值仿真,得出了高速公路设立柔性安全防护网时预留变形空间建议值为1。
5) subject to change without prior notice
预留变量
6) Expression changing by preserving original forms
留形变神
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条