说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 合流制管道系统
1)  combined sewer systems
合流制管道系统
1.
On the basis of analysis of combined sewer systems operator s experiences, an method that minimization of CSO using fuzzy control theory is presented for a representative three-reservoir system, thi.
合流制管道系统是典型的大规模系统,很难用传统的控制方法来防止污水溢出。
2)  Ammonia Refrigeration System Piping
氨制冷系统管道
3)  combined sewer system
合流制排水系统
1.
Pollutant characteristics and first flush effect of runoff in combined sewer system;
合流制排水系统降雨径流污染物特征及初期冲刷效应
2.
The remake of combined sewer system is an important key link of old city proper remake and water environmental protection in city.
合流制排水系统改造是旧城改造建设与城市水环境保护的重要环节。
4)  Combined sewerage system
合流制排水系统
1.
,a thorough analysis of the present conditions of old drainage pipe-works which is a combined sewerage system spreading in three different districts located at the center of Zhuji City,was conducted and multi-measures for improving old drainage system was adopted.
对诸暨市城中区三个不同区域合流制排水系统的地形条件、污染源性质、污水量、道路现状、施工条件及工程资金情况等进行综合分析后 ,分别采取了不同的改造措施 ,其实施效果良好。
2.
In order to obtain the processes of hydrology and water quality of urban combined sewerage system (CSS) in highly urbanized region,the precipitation,discharge and pollutant concentration of four different intensity rainfall (light rain,moderate rain,heavy rain and storm) were measured from Jul.
为了解城市合流制管道系统降雨径流的水文水质变化过程与特征,于2007年7~9月对上海中心城区合流制排水系统(CSS)4类强度降雨(小雨、中雨、大雨和暴雨)的降雨量、径流量和污染浓度进行了同步连续监测与分析。
5)  runner system
流道系统
1.
A complete design strategy for runner system is proposed.
通过总结流道系统的设计知识 ,结合基于特征的设计、专家系统技术和 CAE分析工具 ,对流道系统进行完整全面的设计 。
2.
A complete design strategy for injection mold runner system is proposed in this paper.
通过总结注塑模流道系统的设计知识,结合基于特征的设计、专家系统技术和CAE分析工具,对流道系统进行完整、全面的设计。
6)  pipeline system
管道系统
1.
Research on technology of SVG-based pipeline system
基于SVG的管道系统技术研究
2.
The result shows that the water hammer effect,which resulted from a sudden close up of a block valve downstream the check valve in discharge pipeline and create overpressure in pipeline system and cause its overloaded and fatigue should be considered which design and sellect the structure of the check valve.
止回阀一般安装在流体输送机泵出口管道及防止流体逆流的管道上 ,通过对管道系统中的止回阀在下游阀门短时间内关闭时的水击模拟分析 ,提出在止回阀设计中应考虑水击压力对阀门过载和疲劳破坏的影响以及止回阀结构对管道系统产生水击的作
补充资料:管道SCADA(见管道数据采集与监控系统)


管道SCADA(见管道数据采集与监控系统)
popeline supervisory control and data acquisition system

  管道SCADA(PIPelinesuPervisory eontroland data aequisition system)与监控系统。见管道数据采集
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条