1) loss reduction rate
损耗降低率
1.
The loss reduction rateηis related to the reactive power compensation degree of K and installation point distance of reactive compensation devices to transformer substation busbar distance and line length ratio L.
通过分析说明,在10 kV配电线路上安装无功补偿装置,可以达到降损的目的,而损耗降低率η与无功补偿度K、无功补偿装置安装点离变电站母线的距离与线路长度之比L有关。
4) reducing loss due to reactive power
降低无功功率损耗
5) low power loss
低功率损耗
1.
According to high frequency switch mode power supply transformers’ requirements for the high property power ferrite materials,it had been analyzed and researched that effects of the mainly formula,small additives and sintering technology on ferrite material’s characteristics such as high initial permeability(μi),saturation flux density(Bs) and low power loss(Pc).
根据高频开关电源变压器对高性能功率铁氧体材料的要求,分析研究了主配方、微量添加物和烧结工艺对铁氧体材料的高起始磁导率(μi)、饱和磁通密度(Bs)、低功率损耗(Pc)等特性的影响,得出:通过采取优选主结构原材料配比、掺入适量的CaO、SiO2、TiO2、Co2O3等添加物,并与烧结工艺相匹配等措施,即可制得PC44、PC50等高性能功率铁氧体材料。
6) to reduce line lose rate
降低线损率
补充资料：介质损耗角正切试验(见电容率与损耗因数试验)
介质损耗角正切试验(见电容率与损耗因数试验)
dielectric loss tangent test
)!eZh.sunhooJ一002匕engq一e sh一yon介质损耗角正切试验(dieleetri。1055 tangenttest)见电容率与损耗因数试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条