说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 下渗水形状系数
1)  figure coefficient of infiltration water
下渗水形状系数
1.
Based on water balance model,this paper analyzes the relationship between figure coefficient of infiltration water and figure coefficient of surface storage under the condition of border irrigation.
基于水量平衡模型,通过引入畦灌下渗水形状系数、地表储水形状系数,并分析了两系数的变化规律,发现下渗水形状系数受地表水推进过程中的推进距离和时间的幂指数影响很小,可用一个稳定值计算,由此建立了基于水量平衡法的畦灌时反推田面糙率简化模型。
2.
The power index of movement distance and time has little influence on the figure coefficient of infiltration water in the course of surface water movement,which can be substituted by a stabl.
该文依据水量平衡模型,分析畦灌下渗水形状系数、地表储水形状系数的变化规律,结果表明下渗水形状系数受地表水推进过程中的推进距离和时间的幂指数影响很小,可用一个稳定值代替,由此建立了基于水量平衡原理的畦灌水流推进简化解析模型。
2)  subsurface factor
地表下储水形状系数
3)  submerged block coefficient
水下方形系数
4)  Permeability [英][,pə:miə'biliti]  [美][,pɝmɪə'bɪlətɪ]
渗水系数
1.
Study on Permeability Coefficient of Asphalt Mixture;
沥青混合料渗水系数的研究
5)  permeability coefficient
渗水系数
1.
Then,the permeability characteristics of asphalt mixtures with different gradations were analyzed with the new device and the permeability data were analyzed statistically,on this basis and with reference to the related specification at home and abroad,the critical permeability coefficients of asphalt mixtures were presented.
首先基于合理的渗水理论选用了适宜的新型渗水仪器,并与现规范仪器进行了性能对比,验证了新型渗水仪试验结果的适用性;然后使用该渗水仪对不同级配类型沥青混合料的渗水特性进行了综合分析,同时对各种沥青混合料的渗水数据做了统计处理,以此为基础并参考国内外技术标准提出了沥青混合料的统一临界渗水系数;最后通过临界渗水系数与渗水曲线确定了不同沥青混合料满足渗水要求的临界空隙率,并以此为基础提出了AC类沥青混合料的空隙率标准。
6)  shape coefficient
形状系数
1.
Improved load shape coefficient method in low voltage line loss calculation
低压电网线损计算中的改进形状系数法
2.
25mm)and shape coefficient on the settling velocity were discussed,finally three correlative mathematical models were set up,which established the theoretical foundation for studying WMFS's fluidization and technological parameters.
25mm)及形状系数对沉降末速的影响,最终建立了3个相关的数学模型,为水介质流化床分选机流态化以及工艺参数研究奠定了理论基础。
3.
This paper put forward a new method, in which digital elevation model (DEM) was used to differentiate sub-basins and to extract average slope and maximum length of flow concentration which makes a positive contribution to calculate shape coefficient.
提出一种方法,利用数字高程模型(DEM)划分子流域,提取各单元流域的平均坡度和最大汇流路径长度,以最大汇流路径长度推求形状系数,并将形状系数和平均坡度引入模型结构中,建立其与汇流参数之间的相关关系,使新安江模型能同时考虑降雨、流域形状以及地形分布。
补充资料:渗水系数
分子式:
CAS号:

性质: 水的层流状态通过粉体层时,用渗水系数表示其透过性能。不仅对水,而且对一般流体也叫渗水系数。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条