1) C2 nodes
指控节点
1.
A dynamic regroup arithmetic about the C2 Nodes of the SAM tactical units in its dynamic regroup system is researched,the idea of the arithmetic foundation is discussed,and the excellent selection arithmetic about the C2 nodes of the same and different SAM weapon system tactical units is presented.
研究了地空导弹动态组网系统中的战术单位指控节点动态重组算法。
3) control node
控制节点
1.
A kind of hard circuit and soft design of the CAN control node based on SJA1000 is presented.
介绍了CAN总线的特点以及一种新型的独立CAN控制器SJA1000的主要功能,给出了一种基于SJA1000的CAN控制节点的硬件电路及软件设计,并对设计中应注意的问题进行了较详细的说明。
2.
Hardware of a current loop output control node with Ethernet communications and its Dynamic C driver program are presented.
本文介绍了具有以太网通信能力的电流环输出控制节点的硬件电路和DynamicC驱动程序的开发。
4) controllable node
可控节点
5) front-end node
测控节点
1.
Discussion is made on the software function, the configuration of the control system and the hardware of the front-end node that takes the micro-controller 80C552 as its core.
文章介绍了基于 CAN总线的一个数据采集与控制系统的设计 ,并具体讨论了以微控制器 80 C5 5 2为核心的 CAN总线测控节点的硬件接口电路设计、控制系统的总体结构及软件功能。
2.
Discussion is made on the software function,the configuration of the control system and the hardware of the front-end node that takes the micro-controller 80C552 as its core.
本论文中论述了CAN总线的基本原理与技术规范；具体讨论了以微控制器80C552为核心的CAN总线测控节点的硬件接口电路设计、控制系统的总体结构及软件功能；并设计一基于CAN总线的计算机温度控制系统。
6) main controlling node
主控节点
1.
On the basis of this,this paper introduces the specific function and structure characteristic of the main controlling node and other sub-node in details,not only completes the design of hardware but also the design of software of all the sub-node,with a conclusion of implementation of the online real-time monitoring.
在此基础上,详细介绍了主控节点及其他子节点的具体功能及结构特点。
补充资料：指控
1.就某人某事向司法部门提出控告。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条