1) switched current
开关电流
1.
A new clock-feedthrough reduction technology for switched current circuits;
一种开关电流电路时钟馈通误差补偿新方法
2.
An Analytical Method of Switched Current Networks in Frequency Domain;
开关电流网络的频域分析方法
3.
The implementations of the proposed architectures by using switched current techniques are discussed,and simulative results illustrating the validity of the proposed techniques by Pspice5.
以等效电源为变量 ,构造了线性模拟电路故障诊断的优化神经网络 ,基于罚函数方法提出了开关电流神经优化求解器 ,并给出实例 ,由Pspice验证其可行性 。
2) switched-current
开关电流
1.
An improved method for implementation of wavelet transform utilizing switched-current filters
一种改进的开关电流滤波器实现小波变换的方法
2.
Discrete-time chaotic circuits realizing a tent map is synthesized using on switched-current(SI) techniques.
基于开关电流技术实现了Tent映射离散时间混沌电路。
3.
This paper proposed a method for the implementation of continuous wavelet-transform (CWT) using switched-current (SI) technology, based on current mode and a substitute of switched-capacitor.
提出了一种基于电流模的开关电流技术取代基于电压模的开关电容技术实现连续小波变换的方法。
3) switching current
开关电流
1.
The expressions of the ratio of the reversed domain volume to the system volume Q(t) and the reversal rate dQ/dt which is closely related to the switching current, are given for cubic domain reversals.
将Orihara-ishibashi铁电体统计理论用于三维立方铁电体,求出立方铁电畴反转过程中的反转体积比Q(t)和与开关电流相关的反转速率dQ/dt的表达式,并对不同系统尺寸作了数值计算。
2.
The analytical expressions of the ratio of domain volume to the system volume and the switching current are given for square polarization domain reversals.
结果表明 ,最大开关电流随系统尺寸l增大而上升 ,开关时间在系统尺寸l<0 。
5) current switch
电流开关
1.
The influence of current switche s on output glitch of high-speed current-steering CMOS D/A converter is thoroughly analyzed.
系统分析了高速电流型CMOS数模转换器中电流开关对输出毛刺的影响 ,给出了减小输出毛刺的方法 。
2.
A new design of BJT analog switch using high speed unit such as emitter follower,current mirror and unsaturated current switch is presented.
本文采用射极跟随器、电流镜、非饱和电流开关等高速单元电路设计了一种新颖的BJT模拟开关 。
6) ZCS
零电流开关
1.
Modeling and Simulating for Zero-Current-Switching (ZCS) Quasi-resonant Converters(QRC) based on MATLAB;
基于MATLAB的对零电流开关准谐振变换器的建模与仿真
2.
An improved Buck ZCS-PWM converter was presented in this paper,in which the functions were simulated.
该变换器以恒频方式工作,直流传输比简单,负载特性良好,主管与辅助管可实现零电流开关,与传统的ZCS-PWM变换器相比具有更好的可靠性,仿真研究结果与理论分析相一致。
3.
The characteristics of a new zero current switching (ZCS) - PWM cell are analyzed.
分析了一个新的零电流开关(ZCS)单元电路的特性。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条