1) modeling test
模化试验
1.
Based on modeling test,study has been made on the influence of blade screw angle and screw open structure of 12.
通过模化试验,研究热功率为12。
2.
Based on modeling theory and three-dimension numerical simulation,a modeling test method about the steam-solid two-phase flow within the regulating stage nozzles of supernormal parameter steam turbine was investigated.
基于相似与模化理论和三维数值模拟方法,对超常参数汽轮机调节级喷嘴内汽固两相模化试验方法进行了研究。
2) modularization test
模化试验
1.
It is discovered through cold mode modularization test and numerical simulation of boilers that the fume temperature deviation at the furnace chamber outlets of this type of boilers is mainly caused by different ways of introducing cubic wind and the elevation of cubic wind.
以鸡西热电有限责任公司2号锅炉在168h试运过程中出现的左右两侧蒸汽温度特别是再热蒸汽温度偏差大的问题为研究对象,通过锅炉冷态模化试验和数值模拟发现,三次风的不同投入方式及三次风标高是影响该型锅炉炉膛出口烟温偏差的主要原因。
2.
The results of modularization test in cold condition indicates the dust efficiency can reach 98% without changing I.
冷态模化试验的结果表明，新型水膜除尘器的除尘效率在不改变引风机和水耗的前提下可达到９８％ 。
3) cold model testing
冷态模化试验
1.
The results from cold model testing are proved to be authentic and provide a basis for design of caps in large scale circulating fluidized bed boiler.
本文对内嵌逆流柱形风帽进行冷态模化试验,根据相似理论由风帽冷态试验参数推导出热态运行参数,为循环流化床锅炉布风板的设计提供依据。
5) hardening simulating experiment
强化模拟试验
1.
In this paper,through room hardening simulating experiment,a study on weathered shale filler for the Shuibuya project has been performed in the aspects of its mineral compositions,chemical composition,grain composition etc.
通过室内强化模拟试验 ,对水布垭心墙堆石坝页岩风化填料的矿物成分、化学成分、颗粒级配的长期稳定性进行了研究。
6) visual model test
可视化模型试验
补充资料：杯模流动试验
分子式：
CAS号：
性质：测定热固性树脂成型时流动性的一种试验方法。将试样加入标准杯模中，在规定温度和压力下，测定杯模完全闭合所需的时间。
CAS号：
性质：测定热固性树脂成型时流动性的一种试验方法。将试样加入标准杯模中，在规定温度和压力下，测定杯模完全闭合所需的时间。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条