1) hold-down
[英]['həulddaun] [美]['holddaʊn]
抗倾覆锚固件
1.
However,while some building codes provide methods for estimating shear wall deflections,these methods are not adequate for shear walls without hold-downs.
尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法,但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
2) anti-overturning
抗倾覆
1.
Through theory analyzing piling up excavation temporarily,if slope βanti-overturning and anti-collapsing.
经理论分析,临时堆放的挖方,在坡度β<土壤内摩擦角ф和无暴雨、大风的情况下,能处于稳定的状态;弃渣场必须修建挡渣墙,挡渣墙的稳定性涉及到抗滑、抗倾覆和抗塌陷三个方面,满足该三方面的稳定性要求,挡渣墙才能达到稳定状态。
2.
The design result can meet the requirements of anti-sliding, anti-overturning and ground capability check.
该方法避免了繁琐的试算过程,且结果能同时满足抗滑移、抗倾覆稳定性及地基承载力验算要求。
3.
The allowable range of safety factor of anti-overturning is derived by considering the check of anti-overturning and ground bearing capacity together.
通过综合考虑抗倾覆稳定性与地基承载力验算,推导了抗倾覆安全系数的允许取值范围表达式,不需进行基底偏心距的计算,即可直接判断出所设计的挡土墙能否满足地基承载力要求,并定性地分析了地基承载力对抗倾覆稳定性的影响。
3) overturning resistance
抗倾覆
1.
The formula of calculating the overturning resistance of cantilever beam in the Design Code for Brickwork Structures is discussed.
针对砌体结构设计规范中挑梁抗倾覆验算公式的规定，分析了其不足之处，提出了改进的建议。
4) anchorage
[英]['æŋkərɪdʒ] [美]['æŋkərɪdʒ]
抗倾覆力
1.
Finite element analysis of herringbone-like root anchorage in representative soil types;
鲱骨状根构型对典型土体抗倾覆力的有限元分析
5) overturn resistance
抗倾覆
1.
Experimental study on high-rise structure with three-dimensional base isolation and overturn resistance devices
高层结构三维基础隔震抗倾覆试验研究
2.
Three kinds of three-dimensional base isolation and overturn resistance devices(3D-BIORD) were developed,in view of the limitation that there are a few kind of structural three-dimensional base isolators and existent bearings do not have the ability of overturn resistance.
针对目前的建筑三维隔震支座种类少以及不能抗倾覆的缺陷,提出并研制了三类不同的三维隔震抗倾覆支座。
6) tension anchor
抗拉锚固
1.
This dissertation is made up of four parts: the first one is the material and making method of membrane structure; the second is form-finding analysis; the third is cutting pattern finding; the fourth is tension anchor design.
一、索膜结构的材料与制作；二、索膜结构的找形设计；三、索膜结构的裁剪设计；四、索膜结构的抗拉锚固体系(张力锚)设计。
补充资料：α-型抗结晶抗絮凝酞菁蓝
分子式：
CAS号：
性质：红光蓝色粉末。属于稳定α-型晶相。具有良好的耐溶剂稳定性。在溶剂中不发生色光与晶型的转变。日晒牢度7～8级。以铜酞菁母体与甲醛缩合，其产物与N-羟甲基苯二甲酰亚胺反应，生成的N-羟甲基苯二甲酰亚胺衍生物与铜酞菁母体以1:10质量比混合，再经酸溶，析出，过滤，漂洗，干燥得最终产物。用于高档油墨、涂料及塑料的着色。
CAS号：
性质：红光蓝色粉末。属于稳定α-型晶相。具有良好的耐溶剂稳定性。在溶剂中不发生色光与晶型的转变。日晒牢度7～8级。以铜酞菁母体与甲醛缩合，其产物与N-羟甲基苯二甲酰亚胺反应，生成的N-羟甲基苯二甲酰亚胺衍生物与铜酞菁母体以1:10质量比混合，再经酸溶，析出，过滤，漂洗，干燥得最终产物。用于高档油墨、涂料及塑料的着色。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条