1) the equivalent length of plastic zone
等效塑性铰区长度
2) equivalent plastic region length
等效塑性区长度
3) plastic hinge length
塑性铰区长度
1.
In order to assess the ultimate displacement of reinforced concrete columns based on the deformation characteristics in plastic hinge region, it is very important to determine the plastic hinge length reasonably.
为了评估钢筋混凝土桥墩的极限水平位移,根据塑性铰区变形特性,合理确定塑性铰区长度是非常重要的。
4) length of plastic hinge
塑性铰长度
5) plastic zone length
塑性铰分布长度
1.
This paper presents a simplified plastic zone method with consideration of the influences of the plastic zone length on the stiffness matrix for elastic-plastic analysis of steel frames.
对于杆件单元,本文采用了一种变刚度的杆单元模型,建立了考虑塑性铰分布长度影响的构件单元刚度矩阵。
6) equivalent plastic zone
等效塑性区
补充资料：变形区长度
变形区长度
length of deformation zone
b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度，一般以l表示，l=双sina，式中R为轧辊半径，a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.，从2，_劫2.__L___.，~~:，、，~=心R从一二笋.，由于岑~相对于R助小得多，故计算 V-一4’一一4’一’‘’--一一~一，一，·~中均用其近似值l、翻丫天瓦。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条