1) pressure and moment
压弯作用
2) combination of compression and moment actions
压弯共同作用
1.
On the basis of the experiments and adequate parametric analysis by FEM,simplified design formulas are proposed for the loading capability of single-layer glass panels restrained by spoke-shaped hollow connectors and square-shaped solid connectors under out-of-plane load,in-plane load,as well as combination of compression and moment actions.
本文在试验和大量有限元参数分析工作的基础上,提出了夹板式单层玻璃板面外受弯、面内局部承压以及压弯共同作用的受力性能简化设计方法,通过设计方法与试验结果的对比,进一步论证了简化设计方法的有效性。
3) tension-bending action
拉弯作用
4) action moment
作用弯矩
5) unbending
[英][,ʌn'bendɪŋ] [美]['ʌn'bɛndɪŋ]
抗弯作用
6) combined bending and torsion
弯扭作用
1.
Based on the rotating-angle softened truss model theory,a three-dimensional truss model is presented for the analysis of composite steel-concrete beams with open sections under combined bending and torsion.
在弯扭作用下,组合梁截面各单元分别处于一维应力状态(体系1)和二维应力状态(体系2),体系1用来抵抗由弯矩和扭矩引起的截面纵向应力,体系2用来抵抗由扭矩引起的截面剪应力,两者通过截面的纵向应变协调和内力平衡条件联系起来。
补充资料：长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条