1) coupled inductor
耦合电感
1.
A coupled inductor was used to substitute inductor, so that the circulating current in the zero state could be zero.
该变换器用耦合电感代替常规电感,耦合电感通过变压器反射到原边,使变换器在零状态时的环流减小到零,实现了外管零电压开通,内管零电流关断。
2.
Based on the analysis of the shortage of the single-phase Boost converter in the high gain applications,a method of adding an equivalent DC voltage source was proposed,and a type of Boost converter using coupled inductor was described.
在分析普通单相Boost变换器在高增益变换场合显现的不足的基础上,提出了串入等效电压源的概念,采用耦合电感实现了高增益变换。
3.
The auxiliary circuit is composed of an auxiliary switch,a coupled inductor(flyback transformer) and a feedback diode.
辅助电路由辅助开关管、耦合电感(反激变压器)和反馈二极管构成。
2) coupling inductor
耦合电感
1.
Application of the coupling inductor in the interlock parallel Boost-converter;
耦合电感在交错并联Boost变换器中的应用研究
2.
The principle of operation,the selection of snubber capacitors and the design of the coupling inductor are illustrated and verified on a 1kW experimental circuit.
针对其次级整流二极管反向恢复引起的电压尖峰,引入了一种双CDD(一个电容两个二极管)无源无损缓冲电路,详细分析了引入该电路后推挽正激变换器工作模态,并给出了缓冲电容的选取原则和输出滤波耦合电感的设计,最后通过仿真和一台1kW实验样机验证了理论分析的正确性。
3.
In circuit analysis,coupling inductor circuits are very common.
在电路分析中,耦合电感电路是常见的,在这种电路中,耦合电感一般作串联、并联及T型联接,加上它们又存在有顺接与反接两种情况,因此计算起来,不仅相当复杂且不易掌握。
3) coupling inductance
耦合电感
1.
Effects of coupling inductance on interlocks parallel converter s output characteristics;
耦合电感对交错并联变换器输出特性的影响
2.
Analysis of equivalent methods for coupling inductance
耦合电感等效方法的分析
3.
The influence of multiple output coupling inductance to the load cross regulation is analyzed.
功率电路使用无损耗箝位电路实现了变压器磁芯的复位,控制电路使用第三代BICOMS电流控制型PWM,简化了电路设计、降低了噪声敏感度,并分析了多路输出耦合电感对负载交叉调节性能的影响。
4) coupled inductors
耦合电感
1.
In the UPS accumulator cell charge-discharge system,two way flow of energy and stabilization of DC bus voltage was realized by the bi-directional DC/DC converter circuit with coupled inductors,which can improve system efficiency.
利用双向DC/DC变换器电路,实现了不间断电源(UPS)蓄电池充放电系统中能量的双向流动及直流总线电压的稳定,从而提高了系统效率;通过添加耦合电感,使DC/DC变换器具有高升降压比,从而减少了铅酸蓄电池的单体个数,降低了UPS系统的总成本。
2.
filtering network with coupled inductors instead of a independent inductor is introduced in this article,it s mathematic models and frequency analysis are explained.
耦合电感作为变换器设计中的重要部件已经存在很多年了,但其工作机理却没有得到足够的认识。
3.
For the gain of the Boost converter,which operates in the continuous working state,is less than 5,a high-gain Boost converter with coupled inductors was proposed.
针对连续工作状态(CCM)的Boost变换器的升压比小于5这一缺陷,提出了一种带耦合电感的高升压比Boost变换器,详细分析了它的工作过程,推导了等效电抗、升压比等参数,并对电路进行了仿真。
5) tapped inductor
耦合电感
1.
A tapped inductor ia attached at the secondary side of transformer instead of common filter inductor,the voltage induced by tapped inductor reflects to the primary side,which makes the circulating current of converter during the zero state decreas-es to zero.
该变换器以耦合电感取代常规滤波电感,耦合电感所感应出的电压通过功率变压器反射回初级,使变换器在零状态时的循环电流减小直至零,以实现内管的零电流关断。
2.
A tapped inductor was adopted to substitute for the normal inductor,so that the circulating current in the zero state could be reset to zero.
利用耦合电感取代常规滤波电感,耦合电感所感应出的电压通过功率变压器反射回原边,使变换器在零状态时的循环电流减小至零,以实现内管的零电流关断。
3.
To overcome the high voltage stress of the secondary side of the transformer, a novel zero-voltage and zero-current-switching (ZVZCS) three level converter is proposed: The free-wheeling primary current is reset to zero through introducing a tapped inductor attached at the secondary side.
针对零电流技术中因引入储能电容而引起的副边高电压应力问题,提出了一种新型的零电压零电流软开关三电平直流变换电路拓扑:通过耦合电感实现电流回零,通过改变耦合电感的变比来方便地设定原边环流置零时间,降低环流损耗,实现内管的零电流关断。
6) coupled-inductor
耦合电感
1.
Taking advantage of coupled-inductor filter network,the requirement of low ripple is achieved without decrease of the dynamic performance of power supply.
利用耦合电感滤波网络,达到低纹波的要求,同时不会破坏原开关电源的动态性能。
补充资料：电感器(见电感和标准电感器)
电感器(见电感和标准电感器)
inductor
diongon印电感器(inductor)见电感和标准电感器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条