1) releasing water
释水
1.
Influence of absorbing and releasing water performance of water-releasing factor on internal relative humidity of concrete;
释水因子的吸水与释水性能对混凝土内部相对湿度的影响
2.
Influences of absorbing and releasing water performances,variety and density grade of water-releasing factor on volume de.
针对钢管高强膨胀混凝土中水胶比较低和封闭钢管内混凝土难以获得后期反应水分,钢管与混凝土易发生脱空现象,提出掺入释水因子为封闭环境混凝土养护和后期持续稳定膨胀提供机制保障。
3.
The influences of absorbing and releasing water performance of water-releasing factor,and the influence of the variety,density rank of which on electrical resistivity of concrete are studied.
研究了各种释水因子的吸水与释水性能,以及释水因子的种类、密度等级等方面对混凝土电阻率的影响。
2) water-releasing factor
释水因子
1.
Influence of water absorption and release of water-releasing factor on volume deformation of concrete;
释水因子的吸水与释水性能对钢管混凝土体积变形的影响
2.
Influence of absorbing and releasing water performance of water-releasing factor on internal relative humidity of concrete;
释水因子的吸水与释水性能对混凝土内部相对湿度的影响
3.
Effects of water-releasing factor on the internal relative humidity,volume deformation,and compressive strength of high strength micro-expansive concrete in the sealed curing condition were investigated.
提出调节混凝土内部相对湿度的释水因子技术,研究了释水因子对密闭环境下高强微膨胀混凝土内部相对湿度、体积变形以及抗压强度的影响规律。
4) diluted water
稀释水
1.
With vacuum pump-aeratin, DO of diluted water can not approach to 8mg/L all the time and increases hardly in 24h open and quiet next .
对鼓气曝气和抽气曝气两类曝气方法做了对比研究,结果显示:抽气曝气,稀释水DO始终达不到8mg/L,开放静置24h,DO几乎不增加;鼓气曝气30min,稀释水DO已稳定超过8mg/L,鼓气曝气120min后开放静置20h,DO仍有8mg/L。
5) The compacted released water
压释水
1.
In this paper, according to the ancient karst landform, the distribution of the ancient groove, the distribution of the compacted released water and the difference of filling matter in the pores and the ho.
本文从古岩溶地貌、古沟槽展布、压释水分布以及孔洞充填物类型的差异 ,系统分析了储层分布的控制因素。
6) dilution water
稀释水
1.
The results of the research on the relation between the hardness and the temperature of dilution water and the performance of nano-retention aid show that the effects are obvious.
本文对稀释水的硬度、温度对纳米助留剂的影响进行研究,其研究结果表明稀释水质量对纳米助留剂性能的影响是相当大的。
2.
Focused on the typical dilution water headboxes used in paper machines, including FP dilution water headbox of Allimand, MasterJet F/B dilution water headbox of Voith, and OptiFlo, RetroDilu and ValFlo dilution water headbox of Metso, their Mechanisms and control methods of CD basis weight were introduced.
重点介绍目前造纸机上采用的几种稀释水流浆箱(包括Allimand公司的FP流浆箱,Voith公司的MasterJet F/B流浆箱,Metso公司的OptiFlo流浆箱、RetroDilu流浆箱和Va1Flo流浆箱)的工作原理和通过稀释水进行横幅定量控制的方法。
补充资料：释水系数
含水层的一种参数，也称贮水系数。见地下水计算。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条