1) air-jet loom control system
喷气织机控制系统
1.
An air-jet loom control system design based on ARM7 was presented.
介绍了基于ARM7的喷气织机控制系统设计。
2) tumble-jet system,jet control system
喷气控制系统<火>
3) control system of loom
织机控制系统
1.
This article introduced the control system of loom and the hardware design of the USB module,listing the control system′s module map and the SL811HS′s schematic,expatiated the software design of the USB host system,which includes initialization of SL811HS,enumeration of USB equipment,the protocol of Mass Storage and FAT document system.
为改善原有织机控制系统在提综信息存储方式上的不足,通过对目前各种数据存储器的比较分析,提出了一种基于USB的存储方式。
4) Loom Control System
织机-控制系统
5) electronically controlled gas-injection control system
电控喷气控制系统
1.
The aim of project is to develop a set of sensor of automobile electronically controlled gas-injection control system to replace imported similar products, to meet the technique requirement, and to improve the performance of sensor in old system under the lower cost.
目的是研制出一套可以替代国外同类产品的汽车电控喷气控制系统传感器,在降低成本的前提下,达到期望的技术要求,改进原有系统传感器的不足。
6) reaction jets control system
反作用喷气控制系统
1.
The 6 DOF model of an agile missile with high angle of attack and high attitude maneuverability with impulse control or reaction jets control system(RJC) is described in this paper.
首先给出了用于拦截器的姿控脉冲发动机和用于空空导弹敏捷转弯的反作用喷气控制系统的力学模型 ,然后给出了带干扰 (包括风的干扰 )的具有大迎角大姿态机动能力的敏捷导弹的六自由度动力学模型 ,最后利用上述模型对先进空空导弹的越肩发射进行了仿真 ,并给出了部分结果。
补充资料：喷气织机
见喷射织机。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条