1) anti-sliding
抗滑移
1.
The design result can meet the requirements of anti-sliding, anti-overturning and ground capability check.
该方法避免了繁琐的试算过程,且结果能同时满足抗滑移、抗倾覆稳定性及地基承载力验算要求。
2.
The relative parameters are expressed with base width and the relation graphs of conversion factor are presented,and then the cross-section of retaining wall is designed directly by combining the stability requirement of anti-sliding.
在满足挡土墙地基承载力验算要求的基础上,推导了抗倾覆安全系数的允许取值范围表达式,同时将相关参数用截面底部宽度进行表示,并给出了换算系数的关系曲线图,进而结合抗滑移稳定性要求直接进行挡土墙截面设计。
3.
Using rigid piles as foundation of gravity retaining wall wharf,the anti-sliding mechanism of this kind of retaining wall is different from traditional gravity retaining wall.
采用桩基的重力式挡墙抗滑移设计缺乏成熟的计算方法。
2) anti-slipping property
抗滑移性
1.
Testing method of anti-slipping property of yarn;
机织物纱线抗滑移性测定方法
3) stability defending from sliding
抗滑移定
4) anti-sliding checking
抗滑移验算
1.
this paper is concerned with type selection,anti-overturning checking,anti-sliding checking,bearing capacity of foundation checking as well as construction measure,especially,proposes an improved method of anti-sliding checking based on 《Technical Code for Building Slope Engineering(GB50300-2002)》 and the application in engineering is given.
重力式挡土墙是边坡支护基本型式之一,针对其选型、抗倾覆、抗滑移、地基承载力等设计计算方法以及构造措施逐一进行分析,特别是在《建筑边坡工程技术规范(GB50300-2002)》的基础上对抗滑移验算提出改进方法,并给出了工程应用实例。
5) anti-slip coefficient
抗滑移系数
1.
To determine the anti-slip coefficient of the high-strength bolt which connects components of friction surface,it is screwed and determined by torsion and tensile testing machines respectively.
为了测定高强螺栓连接构件摩擦面的抗滑移系数,可以先在扭转试验机上通过扭矩来施拧,然后在拉伸试验机上进行测定。
2.
The K coefficient of the connector for large-sized high strength hexagonal head bolts,the P force of the connector for torque-shear type high strength hexagonal head bolt,and the anti-slip coefficient of the frictional surface of high strength bolts are the crucial properties to be tested in evaluating steel structures for acceptance.
大六角头高强度螺栓连接副扭矩系数的检测,扭剪型高强度螺栓连接副坚固预拉力的检测,高强度螺栓连接磨擦面抗滑移系数的检测,是钢结构材料验收中的重要测量。
6) slip resistance experiment
抗滑移试验
1.
In order to study the slip resistance between main cable and saddle on the middle tower of the three-tower suspension bridge,Jiangsu Province Yangtze Highway Bridge Construction Commanding Department presides at a slip resistance experiment.
泰州长江公路大桥的初步设计中提出三塔悬索桥设计方案,为了研究特定工况下中塔主缆在鞍座内的滑移情况,江苏省长江公路大桥指挥部主持开展了主缆与中主鞍座间抗滑移试验研究。
补充资料：α-型抗结晶抗絮凝酞菁蓝
分子式：
CAS号：
性质：红光蓝色粉末。属于稳定α-型晶相。具有良好的耐溶剂稳定性。在溶剂中不发生色光与晶型的转变。日晒牢度7～8级。以铜酞菁母体与甲醛缩合，其产物与N-羟甲基苯二甲酰亚胺反应，生成的N-羟甲基苯二甲酰亚胺衍生物与铜酞菁母体以1:10质量比混合，再经酸溶，析出，过滤，漂洗，干燥得最终产物。用于高档油墨、涂料及塑料的着色。
CAS号：
性质：红光蓝色粉末。属于稳定α-型晶相。具有良好的耐溶剂稳定性。在溶剂中不发生色光与晶型的转变。日晒牢度7～8级。以铜酞菁母体与甲醛缩合，其产物与N-羟甲基苯二甲酰亚胺反应，生成的N-羟甲基苯二甲酰亚胺衍生物与铜酞菁母体以1:10质量比混合，再经酸溶，析出，过滤，漂洗，干燥得最终产物。用于高档油墨、涂料及塑料的着色。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条