1) relative side friction
相对摩阻力
2) Frictional Resistance
摩擦阻力
1.
Influence of the frictional resistance for deadline anchor axis on weight indicator accuracy;
死绳固定器轴上摩擦阻力对指重表精度的影响
2.
Influences of frictional resistance on flow distributions of the dividing and combining manifolds;
摩擦阻力对分流和汇流联箱流量特性影响
3.
A method for lateral buckling analysis of tubing with frictional resistance in deviated wells was presented.
提出了在斜直井中钻柱正弦屈曲分析时对摩擦阻力的处理方法,给出了考虑摩擦阻力时的屈曲平衡方程,建立了相应的微分求积法列式,用微分求积法时平衡方程直接求解。
3) Friction resistance
摩擦阻力
1.
An experimental investigation on the flow and heat transfer of the narrow-gap annular tube vapor generators.Ⅱ.Friction Resistance.;
窄缝环形管内流动与传热实验研究 Ⅱ.摩擦阻力特性
2.
Based on the analysis of macrostructure and microstructure of the sample after ECAE, the influence of friction resistance between the die wall and the sample on the deformation of the sample billet was discussed.
通过对挤压后纯铝试样的宏观变形及微观形貌分析,探讨了ECAE过程中模具内壁与试样之间的摩擦阻力对试样变形的影响,得到了滞变区比例与挤压位移之间的关系。
3.
In daily mine ventilation work,we treat as airway friction resistance factor a constant.
在矿井通风业务实际计算中认为 :对于某特定巷道的摩擦阻力系数视为一定值 ,不考虑其随风流流向改变而改变。
4) friction force
摩擦阻力
1.
In this paper,the effect of friction force on metal forming parameters has been summarized based on some last research reports.
论文基于近期已发表的文献 ,综述了摩擦阻力对金属成形参数的影响。
2.
The paper introduces the method and principle of testing friction force between mould plates and strand on the slab caster.
介绍了板坯连铸机结晶器铜板与铸坯摩擦阻力的测试原理和方法，分析了铜板与铸坯之间的摩擦状态与摩擦阻
3.
What s more,the produced friction force and the added moment,which act on the transmission shaft,influence equipment performance and increase equipment load.
通过对齿轮联轴器工作时的运动和受力分析得知,当补偿轴向位移、径向位移和角偏差时,在接触齿面之间存在滑动摩擦,滑动速度较大,使齿轮联轴器容易磨损破坏;并且在传动轴上产生摩擦阻力和附加弯矩,影响设备性能,增大设备负荷。
5) Friction pressure
摩阻压力
6) pipe-friction head loss
水力摩阻
1.
Based on the popularity of computer and the adapted Colebrooks formula, in the paper a new equation for pipe-friction head loss is put forward in pipeline.
长输管道输送一般处于紊流区,紊流区的水力摩阻计算一直采用分区计算的方法,涉及到的公式较多,使用起来不方便,并且分区附近存在数值跃变;由于混合摩擦区的计算通常采用近似公式,误差增加,最大甚至可达百分之十几。
补充资料：肺循环阻力(或全肺阻力)
肺循环阻力(或全肺阻力)
pulmonary circulation resistance
血液在肺部血管内流动时和血管壁之间的摩擦力和血液内部的摩擦阻力。肺动脉管壁较薄，分支短而管径大，故肺动脉的可扩性较大，对血流的阻力很小，仅0.12PRU(外周阻力单位)。肺循环动脉部分总的阻力和静脉部分总的阻力相等，故血液流动时在动脉部分的压力降落和静脉部分的压力降落相等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条