1) Heat rate
热耗率
1.
Reason of higher heat rate of the 600 MW supercritical turbine
600MW超临界汽轮机热耗率偏高的原因分析
2.
According with ASME standard,from benchmark flux choose,the influence of system inner-leakage and outer-leakage,causes are analyzed on errors of the heat rate results in power plant process report,also countermeasures are put forwards.
根据ASME标准,从基准流量的选择,系统工质内漏、外漏的影响等方面,对发电企业生产报表中热耗率计算结果存在偏差的原因进行了详细的分析,并给出改进建议。
3.
From the aspects of the reference flow, internal leak-off flow and external leak-off flow of unit, the root of the approximate results in heat rate calculation is analyzed, and the suggestion to improve advice is given.
发电企业生产报表中热耗率指标的计算缺乏明确标准依据,其计算结果的近似性是导致发电厂正、反平衡煤耗数据不统一的重要因素之一。
2) heat consumption rate
热耗率
1.
Reason of higher heat consumption rate of 150MW steam turbine and countermeasures
150MW汽轮机组热耗率高的原因及对策
2.
The economic analysis and comparison of two modes show that the use of steam-driven feed pumps in 200 MW and larger units can reduce net heat consumption rate and increase the output of the unit.
文章通过对汽动方案与电动方案进行经济性对比分析, 得出了对于200 MW以上的机组,小汽轮机驱动给水泵节约了厂用电,降低了发电净热耗率,增大了主机的出力,降低了综合成本煤耗率,使机组的运行经济性得到了明显提高。
3.
Through the technical modernization of LPturbine,to reduce the heat consumption rate about 282.
分析漳泽发电厂K—215—130—1型汽轮机热耗大、经济性差的原因,通过低压缸技术改造,在额定工况下可降低整机热耗率约282。
3) specific heat consumption
热耗率
1.
In the event of reducting load in operation of ultra-supercritical units to 60% of their rated load, the specific heat consumption of said units will be lower than that of supercritical 600 MW units under rated operating condition; in case the.
超超临界机组运行负荷降低至60%额定负荷时,其热耗率将低于超临界600MW机组额定工况时的热耗率;超超临界机组负荷低于40%额定负荷时,其热耗率设计值将低于亚临界300MW、600MW机组额定工况时的热耗率;超超临界机组在低于60%额定负荷后,热耗率出现加速上升的趋势。
5) the dissipation rate of thermal variance
热耗散率
6) heat rate
耗热率
补充资料：耗耗
1.方言。老鼠。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条