1) extruding magnitude of interference
挤压过盈量
2) interference extrusion
过盈挤压
1.
Starting from the principle of the metal plastic deformation, this paper discusses on the design of rigid rebound bending die, which includes the comparison of the die structure, and the selection and the calculation of the magnitude ofthe interference extrusion, etc.
从金属塑性变形原理出发,论述了无弹性回跳弯曲模的设计,包括模具结构对比、过盈挤压量的选择和计算。
3) force fit
过盈压入
1.
1%force fit level i s best for prolonging fatigue life of jointing structure.
过盈压入是提高孔连接结构抗疲劳破坏能力的经济而有效的措施。
4) Pinch pressure
过盈压力
5) interference
[英][,ɪntə'fɪərəns] [美]['ɪntɚ'fɪrəns]
过盈量
1.
The finite element method is applied to simulate the cold expanding of the joint as well as the bell and spigot fitting process of internal and external pipes, therefore to determine the interference and overlapping length, analyze the joint forces and give the uniform strength condition of joint and pipe.
文章针对D159mm×8mm无缝钢管进行了压接工艺条件下力学计算与分析,利用有限元方法模拟无缝钢管冷态下胀口和内外钢管承插配合过程,确定了内外钢管对接承插过盈量及搭接长度,分析了压接接头的受力情况,给出了压接接头与钢管等强的条件,为压接接头配合参数设计及工艺试验提供了依据。
2.
The analysis results show tha t the larger interference between the spindle and the toolholder or a higher draw bar force is benefit to improving th.
研究表明 ,适当提高过盈量 (轴向拉力 )对于提高主轴 /刀柄联接特性具有积极意
6) shrink range
过盈量
1.
Analysis and experiment of the optimum shrink range between chain plate and bush for agricultural machinery chain by using finite element method;
农机链链板与套筒最优过盈量有限元分析及试验研究
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条