3) maximum revolutions of output shaft
输出轴最大转数
4) output torque
输出转矩
1.
In this paper,the working principle and the constitution of the experimental bench of me- chanical stepless variable-speed transmitting are recommened in detail,and the output torque,the theoritical value and the measuring value of mechanical efficiency of the XYZW —750 stepless variable—speed device are given.
本文介绍了机械无级变速传动试验台的工作原理、结构,并给出 XYZW-750型机械无级变速器的输出转矩、效率的理论值及实测值。
2.
Based on the single DC motor model,the mathematic model of dual-motors was established to analyze the problem of output torque balance of dual-motors.
这一特殊结构使得正反转电机的驱动问题尤其是输出转矩平衡问题显得尤为突出。
3.
And then the output torque was calculated.
用虚位移法计算了电磁转矩和电磁吸力,用摩擦定律计算了摩擦转矩,进而计算出输出转矩。
6) maximum torque
最大转矩
1.
Based on the electro-technology theory,this study defines the ratio of maximum torque Tm to starting torque Tst as the starting modulusλst,and reaches a conclusion that X20 can be calculated by using the rotor phase resistance r2 and the starting modulus A,,.
针对异步电动机转子相电阻r2容易测量,而转子相感抗X20不易测得,且尚无计算X20关系式的现状,以电工理论为基础,定义电机最大转矩Tm和起动转矩Tst的比值为启动系数λst,分析得出了用转子相电阻r2和启动系数λst计算X20的公式。
2.
A maximum-torque slip frequency control method is proposed to meet the requirements of mining locomotives and remedys the weaknesses of traditional slip fre quency control such as the PI parameters are hard to determine,the current-slip curve is hard to realize by MCU and the maximum torque can not be obtained.
在分析和比较现有交流牵引驱动系统的控制方法的基础上,针对窄轨电机车的实际工程需求,提出了具有最大转矩输出能力的改进型转差频率控制方法。
3.
The circular graph which comes from circular theory and motor equivalent diagram,shows running characteristic clearly and to determine motor parameter via geometric relations:such as losses,efficiency, maximum torque and so on.
由圆图分析法结合异步电机Γ型等效电路图推广而来的电机圆图,可以很形象地表明电机运行特性以及通过几何关系间接地确定电机的某些性能,如损耗、效率、最大转矩等,但作图较为繁琐而且精确度受影响。
补充资料：最大输出电平
分子式：
CAS号：
性质：在录放音过程中，lkHz及其以下中低频信号，当其三次谐波失真达到规定值(如3%，5%)时的重放输出电平，叫最大输出电平。用对参考电平的相对分贝(dB)值表示。一般地说，这个值越大的磁带，其记录大信号的能力越强。这个值较低的磁带在录音信号电平较高时会出现轻轻的失真声。所以，MOL值越高的磁带其质量也越好。
CAS号：
性质：在录放音过程中，lkHz及其以下中低频信号，当其三次谐波失真达到规定值(如3%，5%)时的重放输出电平，叫最大输出电平。用对参考电平的相对分贝(dB)值表示。一般地说，这个值越大的磁带，其记录大信号的能力越强。这个值较低的磁带在录音信号电平较高时会出现轻轻的失真声。所以，MOL值越高的磁带其质量也越好。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条