说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 多支盘桩
1)  bored pile with expanded branches
多支盘桩
1.
In this paper,the application of a bored pile with expanded branches in the soft soils was expounded.
阐述了挤扩多支盘桩在软土地区的应用情况,通过现场静载荷试验,分析了钻孔灌注桩和挤扩多支盘灌注桩的承载力,采用高应变动力试验方法,研究了多支盘灌注桩的承载性质,从而提高了支盘的承载力。
2)  pile with branches and plates
挤扩多支盘桩
1.
This paper introduces the use of cast-in-place pile with branches and plates in the actual engineering cases,and comparison is conducted between this particular type of usage and the common use of cast-in-place pile under the same working conditions.
介绍了挤扩多支盘桩在工程实例中的应用,并对工程同场地内的挤扩支盘桩与普通钻孔灌注桩进行承载力和沉降的对比试验研究。
2.
Compared with column bored pile,the bored pile with branches and plates is a new type of piles with higher bearing capacity and lower settlement.
针对挤扩多级支盘桩相对于普通等截面直孔灌注桩具有较高承载力和较低沉降量的特性,采用自平衡静载荷试验方法,对浙江湖州市某工程同一场地中的挤扩多支盘桩与普通等截面直孔灌注桩进行极限承载力的对比试验研究。
3)  branch-cement-soil pile
多支盘水泥土桩
1.
Non-linear finite element method analysis on branch-cement-soil pile;
多支盘水泥土桩的非线性有限元分析
2.
The analysis of finite element method of branch-cement-soil pile;
多支盘水泥土桩变形特性的非线性有限元分析
4)  cast-in-place pile with branches & plates
多支盘灌注桩
5)  multi branch pile by extrusion
多分支承力盘桩
6)  squeezed branch pile
支盘桩
1.
By studying the data of pile test of a certain engineering,this paper probes into the features of bearing capacity of squeezed branch pile and its economic benefit,compares the squeezed branch pile and cast-in-place pile under the same bearing capacity,and discusses the featurews of squeezed branch pile.
通过对某工程试桩资料研究分析,探讨了支盘桩承载特点及其工程经济效益,在同承载力条件下对比了支盘桩和直孔灌注桩,论述了支盘桩的特点。
2.
And the results show that soil parameters affect the bearing capacity of squeezed branch pile significantly.
采用有限元分析的方法,对支盘桩桩周土的内摩擦角、粘聚力、桩土界面间摩擦系数、桩土弹性模量比等因素对支盘桩的承载力的影响进行非线性有限元分析。
3.
The extraction-resistant behaviors of squeezed branch piles are analyzed with large FEM software ABAQUS and compared to the compression-resistant behaviors.
用大型有限元软件ABAQUS分析了挤扩支盘桩的抗拔特性,并与抗压特性进行了比较。
补充资料:多苯基多亚甲基多异氰酸酯
    多苯基多亚甲基多异氰酸酯,简称PAPI,或称粗MDI,浅黄色至褐色粘稠液体.有刺激性气味。相对密度(20℃/20 ℃)1.2,燃点218℃。PAPI实际上是由50%MDI与50%官能度大于2以上的多异氰酸酯组成的混合物。升温时能发生自聚作用。溶于氯苯、邻二氯苯、甲苯等。PAPI的活性低,蒸气压低,只是TDI的百分之一,故毒性很低。
    用于制造聚氨脂胶粘剂。也可直接加入橡胶胶粘剂中,改善橡胶与尼龙或聚酯线的粘接性能。贮存于阴凉、通风、干燥的库房内,远离火种、热源。严格防水、防潮,避免光照。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条