1) recycled fine aggregate
再生细骨料
1.
Influence of particle shaping on property of recycled fine aggregate;
颗粒整形对再生细骨料性能的影响
2.
Effect of powder in recycled fine aggregate on compressive strength of recycled mortar
再生细骨料中粉料对再生砂浆抗压强度的影响
3.
The present research investigated the quality of both the simple-crushing and the particle-shaping recycled fine aggregate concrete.
研究了简单破碎再生细骨料和颗粒整形再生细骨料混凝土的强度,重点讨论了再生细骨料种类、取代量、粉煤灰和胶凝材料用量等因素对再生混凝土强度的影响。
2) recycled(coarse and fine) aggregate
再生(粗、细)骨料
3) recycled aggregate
再生骨料
1.
Comparison of mechanical properties between recycled aggregate concrete and control concrete at identical mix proportions;
同配合比条件下再生骨料混凝土与基准混凝土的力学性能比较研究
2.
Review of research on recycled aggregate concrete;
再生骨料混凝土研究述评
3.
Analyses and evaluation of the behaviour of recycled aggregate and recycled concrete;
再生骨料及再生骨料混凝土的性能分析与评价
4) recycled aggregates
再生骨料
1.
Research on the pressure deformation properties of perforated recycled aggregates concrete brick masonry;
再生骨料混凝土多孔砖砌体受压变形性能试验研究
2.
Study on building waste recycled aggregates classifying and its physical characteristics
建筑固体废弃物再生骨料的分类及其物理性能研究
5) recycled coarse aggregate
再生粗骨料
1.
Experimental research on characteristic of recycled coarse aggregate after high-temperature;
高温作用后再生粗骨料特征性能试验研究
2.
Influence of particle shaping on the workability of recycled coarse aggregate concrete;
颗粒整形对再生粗骨料混凝土工作性的影响
3.
Basic properties of recycled coarse aggregate concrete by orthogonal analysis
正交法分析再生粗骨料混凝土的基本性能
6) recycled aggregate
再生粗骨料
1.
Based on geometrical characteristic of recycled aggregate and it s influence to the microscopic structural of recycled aggregate concrete,the thesis mainly analyzes the causes for lower durability of recycled aggregate concrete than common concrete.
基于再生粗骨料的几何特征及其对再生混凝土微观结构的影响,分析了再生混凝土耐久性较普通混凝土差的原因。
2.
The other factors are recycled aggregate,water cement ratio,high efficiency water reducing agent and fly ash.
采用再生粗骨料配制高强度混凝土,研究再生高强混凝土的抗拉性能。
补充资料：染料细粉及超细粉
分子式：
CAS号：
性质：非水溶性染料或不易溶染料常采用的剂型。如分散染料、还原染料等对粒度及粒度分布均有一定要求，要求相对集中，过细、过粗，均对使用有不良影响。染料生产企业对本企业的产品均作了规定。这些染料产品一般多在2μm到上到4μm范围内，如对某些分散染料要求控制在1μm左右，分散性能4～5级，还原染料也与分散染料近似，故有超细粉之称。为使染料产品达到上述细度，常采用万能粉碎机或砂磨、球磨等进行粉碎。
CAS号：
性质：非水溶性染料或不易溶染料常采用的剂型。如分散染料、还原染料等对粒度及粒度分布均有一定要求，要求相对集中，过细、过粗，均对使用有不良影响。染料生产企业对本企业的产品均作了规定。这些染料产品一般多在2μm到上到4μm范围内，如对某些分散染料要求控制在1μm左右，分散性能4～5级，还原染料也与分散染料近似，故有超细粉之称。为使染料产品达到上述细度，常采用万能粉碎机或砂磨、球磨等进行粉碎。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条