1) Variable nip crushing chamber
变啮角破碎腔
2) crushing cavity
破碎腔
1.
This paper made a theoretical analysis of designing crushing cavity of Fine Cone Crusher.
本文对细碎圆锥破碎机破碎腔的设计进行了理论分析、提出了改进方法并进行了工业试验论证。
3) Crushing chamber
破碎腔
1.
Several typical shapes of crushing chamber of cone crusher at home and abroad and the wear of the crushing chamber were introduced, the design principle of traditional crushing chamber was described, and the crushing chamber was reasonably designed using liner wear curves, thus the technical index of the crusher was increased and service life of liner was prolonged.
介绍了国内外几种有代表性的圆锥破碎机破碎腔型、破碎腔磨损情况 ,叙述了传统破碎机腔型的设计原理 ,并利用衬板磨损曲线对破碎腔进行了合理设计 ,提高了破碎机技术指标 ,延长了衬板使用寿命。
2.
In this paper, on the basis of analyzing the complex swing characteri sties of the points on the plane of moving jaw, the reasonable mobile state of the crushing stone in crushing chamber are defined, and the methods for analyzing and computing the falling height of the each crushing layer and its packing density are presented.
本文在动腭齿面复杂摆动特性定量分析基础上,分析确定了物料在破碎腔内的合理流动状态,提出了腔内各物料层一次落料高度以及相应填充密度的分析和计算方法。
4) the cavity mould of the crusher
破碎腔型
5) Variable nip angle
变啮角
6) chamber division
破碎腔分层
补充资料：齛啮
1.咬，噬啮。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条