说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> BJ01株
1)  BJ 01 strain
BJ01株
2)  strain [英][streɪn]  [美][stren]
菌株、毒株
3)  strains [英][strein]  [美][stren]
菌株
1.
Isolation of strains that can transform linoleic acid to conjugated linoleic acid;
共轭亚油酸转化菌株的筛选
2.
Selection of the superior strains for fixed organic fertilizer;
生物有机肥优势发酵菌株的筛选
4)  bacterial strain
菌株
1.
Isolation and identification of bacterial strains for surfactant degradation;
表面活性剂AE降解菌株的分离筛选及鉴定
2.
Study on breeding of efficient decolorizing bacterial strains for coking wastewater and optimal decolorization condition thereof
焦化废水高效脱色菌株的选育与脱色条件研究
3.
A total of 10 bacterial strains represented as from SB01 to SB10 were isolated from a petrolium-contaminated sludge,and their potential of degrading pyrene(PYR)was investigated on the substrates pyrene(MS1),pyrene plus glucose(MS2),and pyrene plus phenanthrene(MS3).
Glu与PHE对SB04和SB09降解PYR的促进作用无显著差异,而对其它各菌株而言,PHE对PYR降解的促进作用大于Glu。
5)  bacterium [英][bæk'tiəriəm]  [美][bæk'tɪrɪəm]
菌株
1.
Screening of mixed oil-degrading bacterium and their biodegrodation charateristics;
降解原油混合微生物菌株的筛选及其性能
2.
Breeding of a fast retting bacterium and appraisal of retting function in hemp;
大麻快速脱胶菌株的选育与脱胶性能鉴定
3.
1,3-propanediol high production bacterium ultraviolet mutant;
1,3-丙二醇高产变异菌株的紫外诱变选育
6)  plant [英][plɑ:nt]  [美][plænt]
植株
1.
The study of metals in plant samples and its error estimation with microwave digestion and ICP-AES;
微波消解ICP-AES法测定植株金属元素含量的研究
2.
The Relationships between Soluble Sugar Contents of Plant and Kernel and Dry Matter Accumulation in Different High Yielding Wheat Genotypes;
不同类型高产小麦植株、籽粒可溶性糖含量与其干物质积累的关系
3.
Definition and Calculation of Uniformity of Plant Distribution in Crops Field;
植株田间分布均匀度的定义与计算
补充资料:BJ-2落砂机操作规程
1、遵守《铸造设备通用操作规程》有关规定:
2、工作前还必须遵守:
a、打开压缩空气伐门,检查挡车机构和承接模组小车的工作是否正常,如有不正常情况,应通知维修人员处理;
b、检查油泵、伐门、油缸的工作是否正常,如有不正常情况,应通知维修人员处理。c、
按模组高度调好电磁吸盘的高度,
3、工作中必须遵守:
a、当零件进行落砂时,先起动油泵;
b、打开冷却段挡车机构,使焙烧小车进少落砂机。当整个小车全部进入落砂机后,合上落砂机。当整个小车全部进放落砂机后,合上落砂机旁的挡车机构,才允许按下电磁吸按钮,板动手操旋伐,吸取模组;
c、承接小车进入吸盘下部时,注意不要与模组相碰;
d、当该焙烧小车的模组全部吸完后,打开挡车机构,才允许第二个焙烧小车进入;
e、工作中,不允许电磁吸盘压在模组上,以免损坏焙烧小车;
f、 天车吊起模组框时,严防碰撞承接小车。
4、工作后还必须遵守:
a、切断电源后,挡车机构的压缩空气伐门不许关闭,以免因挡车机构失去作用而发生拦车事故;
b、工作后,承接小车应停在落砂机外边的位置上;
c、打扫现场,清理设备时,特别注意将铸工输送机下边的砂皮清理干净,以免堵塞和损坏设备。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条