1) Milling bar
研磨杆
2) internal lap
内研磨杆
4) grinding
[英]['ɡraɪndɪŋ] [美]['graɪndɪŋ]
研磨
1.
Fractal model for particle-size distribution of coal grinding;
基于分形方法的煤炭研磨颗粒粒度分布模型
2.
Preparation of γ-Fe_2O_3 Nanoparticles by Solid(wet)-phase Grinding;
γ-Fe_2O_3纳米粒子的(湿)固相研磨法制备研究
3.
The grinding materials and technology for stainless steel;
不锈钢研磨材料及研磨工艺
5) Lapping
[英][læp] [美][læp]
研磨
1.
Rapid detection of subsurface damage of optical materials in lapping process and its influence regularity;
光学材料研磨亚表面损伤的快速检测及其影响规律
2.
Research on high speed lapping paraboloid workpiece based on bending and forming method;
基于弯曲成形法抛物面高速研磨的研究
3.
Research on the Lapping Uniformity of Uncertain Eccentricity Plane Lapping;
不定偏心平面研磨均匀性的研究
6) polishing
[英]['pɔliʃ] [美]['pɑlɪʃ]
研磨
1.
Polishing Robot System and the Control of Its Motion;
研磨机器人系统及其运动控制
2.
A new way of polishing is discussed, in which the ultrasonic energy is applied to the interface of mechanical polishing and correlative equipment and experimental equipment are designed.
为了提高光纤连接器端面的加工效率和加工质量,改善连接器光传输性能,探讨了在机械研磨的界面上引入超声能的复合研磨方式,设计了相应的超声机械研磨装置。
3.
To improve the material removal rate(MRR),this paper discussed a new ultrasonic polishing in which the ultrasonic energy was introduced to the interface of common polishing,and compared this new polishing process with the common polishing process in the MRR.
为了提高机械研磨的材料去除率,探讨了在机械研磨的界面上引入超声能的复合研磨方式,将机械研磨和引入超声的复合研磨两种方法的去除效率进行了实验对比;发现复合研磨后,去除效率有显著提高;得出超声/机械复合研磨的加工效率明显优于机械研磨。
补充资料：Anglelapping角度研磨
angle lapping 的目的是为了测量junction的深度，所作的芯片前处理，这种采用光线干涉测量的方法就称之angle lapping。公式为xj=λ/2 nf即junction深度等于入射光波长的一半与干涉条纹数之乘积。但渐渐的随着vlsi组件的缩小，准确度及精密度都无法因应。如srp(spreading resistance prqbing)也是应用angle lapping的方法作前处理，采用的方法是以表面植入浓度与阻值的对应关系求出junction的深度，精确度远超过入射光干涉法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条