1)  Methanol
甲醇量
2)  Content Limit of Methanol
甲醇量限度
3)  Methanol
甲醇
1.
A Theoretical Study on the Adsorption and Decomposition of Methanol over SnO_2(110) Surface;
甲醇在SnO_2(110)表面的吸附与解离的理论研究
2.
DW-Spectrophotometric Determination of Methanol in Wine with Reagent 5-Br-PADAP;
5-Br-PADAP双波长分光光度法测定酒样中甲醇
3.
Progress of Modified ZSM-5 Type Zeolite for Preparing Paraxylene from Toluene and Methanol;
改性ZSM-5催化剂在甲苯、甲醇烷基化制备对二甲苯技术的研究进展
4)  methyl alcohol
甲醇
1.
In the operational site air the methyl alcohol examines the new method;
工作场所空气中甲醇检测新方法
2.
Environment problems in production of methyl alcohol with coke gas system;
焦炉煤气制甲醇生产中的环境问题分析
3.
Discussion on the Accuracy Detecting the Content of Methyl Alcohol in Alcohol by Spectrophotometry;
分光光度法检测白酒中甲醇的准确度探讨
5)  Carbinol
甲醇
1.
Direction and application of the development of carbinol industry;
甲醇工业发展的方向及应用
2.
Computing of the Theorectical Burning Temperature of Carbinol and Discussing Heat Efficieney;
甲醇燃烧温度的计算与热效率研究
3.
The Gas Chromatography Simultaneous Determination of Carbinol,n-butyl Alcoholin and Amylene Alcohol in Ambient Air and Exhaust Gas;
气相色谱法同步测定环境空气和废气中甲醇正丁醇叔戊醇
6)  methanol synthesis
甲醇
1.
Advances in the research on methanol synthesis catalyst;
国内外合成甲醇催化剂研究进展
2.
The experiments of methanol synthesis were carried out from biomass derived syngas (CO/H2/CO2/N2=22/47/27/4) with different catalysts.
在模拟生物质合成气气氛(CO/H2/CO2/N2=22/47/27/4,体积比)下对Cu?Zn催化生物质合成气合成甲醇进行活性评价,发现Cu?Zn催化剂合成甲醇活性随反应时间单调下降,40h后Cu?Zn催化剂活性比初始活性下降15%,添加Al能提高Cu?Zn催化剂的稳定性,添加Al后的Cu?Zn?Al及Cu?Zn?Al?Li催化剂40h内合成甲醇的活性均未见明显下降。
3.
At present, the most catalysts studied for methanol synthesis are on the basis of Cu/ZnO/Al_2O_3 catalyst.
采用添加表面活性剂两步沉淀法制备了具有高表面铜相对浓度的超细甲醇合成催化剂。
参考词条
补充资料:甲醇量检查法
【通用名称】
甲醇量检查法
【其他名称】
甲醇量检查法 附录 Ⅸ T. 甲醇量检查法 本法系用气相色谱法(附录Ⅵ E)测定中药酒剂中的甲醇量。除另有规定外, 按下列方法测定。 色谱条件与系统适用性试验 用直径为0.25~0.18mm的二乙烯苯-乙基乙烯 苯型高分子多孔小球作为载体;柱温125℃。理论板数按甲醇峰计算,应不低于 1500;甲醇与内标物质峰的分离度应大于2。 校正因子测定 精密量取正丙醇 1ml,置100ml量瓶中,加水溶解并稀释至 刻度,摇匀,作为内标溶液。取甲醇 1ml,置100ml量瓶中,精密称定,加水稀 释至刻度。精密量取上述溶液和内标溶液各10ml,加水稀释成100ml,摇匀,作 为标准溶液。取 1μl注入气相色谱仪,连续注样3~5次,按平均峰面积计算校 正因子。 测定法 精密量取内标溶液 1ml,置10ml量瓶中,加供试液至刻度,摇匀, 作为供试品溶液,取 1μl注入气相色谱仪,测定,计算,即得。 除另有规定外,每 1L供试液含甲醇量不得超过0.4g。
【附注】
(1)在不含内标物质的供试溶液的色谱图中,与内标物质峰相应的位 置处应不出现杂质峰。 (2)选用其他载体时,系统适用性试验必须符合本法规定。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。