1) photodamage
光损害
2) Laser-induced damage
激光损伤
1.
Its electrical properties have been well characterized, but there is little report about the laser-induced damage properties of SCS.
本文主要对单晶硅的抗激光损伤特性进行研究 ,研究了单晶硅材料在 10 6 4nmNd :YAG激光自由脉冲输出模式和单脉冲输出模式作用下的损伤特性 ,通过对两种激光作用下单晶硅损伤形貌的分析 ,在热效应与热力耦合模型的基础上 ,对单晶硅的激光损伤机制进行了探索。
2.
Defects in thin film are one of the most important factors influencing laser-induced damage in the thin film components, and always a major concern.
薄膜缺陷是影响薄膜元件抗激光损伤的重要因素之一,长期以来一直是人们关注和研究的问题。
3.
When the elements are used under high power condition, the laser-induced damage threshold will is reduced.
在强激光系统中光学元件表面的微结构会引起局域场强增强,进而会影响元件抗激光损伤能力。
3) Laser induced damage
激光损伤
1.
Influence of preparation process on laser induced damage threshold of HfO_2 films;
制备工艺对HfO_2薄膜抗激光损伤能力的影响
2.
Laser induced damage threshold(LIDT) was measured and the damage morphologies were plotted by optical profiler.
采用电子束蒸发技术制备了1 064 nm减反膜,利用超声清洗及激光预处理的方法分别对样品进行处理,并对处理前后的样品分别进行激光损伤阈值测试及破斑深度测量。
3.
The real-time results from laser induced damage to samples using photothermal deflection technique support this model.
文中对样品激光损伤的光热偏转实时观察结果支持了这一模
4) laser damage
激光损伤
1.
Recognition of film laser damage based on wavelet transform;
基于小波变换的薄膜激光损伤识别
2.
Laser damage threshold measurement of the optical elements;
光学元件的激光损伤阈值测量
3.
ZrO_2 is an important material used in high laser damage coatings.
ZrO2是用于高抗激光损伤薄膜的重要材料,其结构及性能与沉积条件有很大关系。
5) photodamage
光损伤
1.
The photodamage threshold of Mg∶Er∶LiNbO_(3) waveguide substrate was tested by m-line method.
采用m线法研究Mg∶Er∶LiNbO3晶体波导基片光损伤阈值。
2.
The values of photodamage resistance ability of In-doped series LiNbO3 crystals were obtained by the facula distortion method.
利用光斑畸变法得到掺In系列LiNbO3晶体的抗光损伤能力,发现在In3+掺入量高于阈值3%时的抗光损伤能力增强,比掺入量低于阈值的晶体高1～3个数量级。
3.
The threshold concentration of～3mol% of In for In:Er:LiNbO_3 was confirmed through the measurements of the absorption spectra and the photodamage resistance ability of In(3mol%):Er:LiNbO_3 is over three orders of magnitude higher than that of Er:LiNbO_3.
通过测试晶体的吸收光谱和抗光损伤能力 ,确定In :Er :LiNbO3 晶体中In的掺杂阈值浓度为～ 3mol% ,In(3mol% ) :Er:LiNbO3 晶体的抗光损伤能力比Er:LiNbO3 提高 3个数量级以上。
6) transmittance loss
透光损失
1.
The transmittance loss of laminated glass due to reflection , absorption and scatter of light is reconfirmed and the steps to reduce transmittance loss are suggested in this paper .
从光的反射、吸收和光散射三方面着重分析了夹层玻璃的透光损失,并提出了相应的减少透光损失的措施。
参考词条
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。