1) infrared detector
红外线检测器
2) infrared
红外
1.
Fast Analysis of Gaseous Pollutant in Environment by Handy Fourier Transform Infrared Spectrometer;
便携式傅立叶红外快速检测环境中气态污染物
2.
Recognition of Plant Parts of Tobaccos Based on Infrared and Near Infrared Spectra;
基于红外与近红外光谱的烟叶部位识别
3.
Studying status of radar and infrared composite stealthy coating materials;
涂覆型雷达/红外复合隐身材料研究现状
3) IR
红外
1.
Study on IR Extinction Performance of Graphite Micro-powder Smoke in Vacuum;
真空中石墨微粉烟幕的红外消光性能研究
2.
Preparation of Paraffin’s Microcapsule and Study on Its IR Simulation and Stealthy Performance;
石蜡微胶囊化及其红外伪装隐身性能研究
3.
The Compatibility of IR Smoke Interfering Material in Shell;
红外烟幕干扰材料在弹中的相容性
4) FTIR
红外
1.
Component analysis and content determination by TG-FTIR for thermosetting compound;
红外与热失重结合解析酚醛复合材料的成分
2.
Synthesis and Characterization of Some Manganese Sulfonates by TG and FTIR;
几种磺酸锰盐的合成及其热重和红外表征
3.
The Fourier transform infrared spectroscopy(FTIR),ultraviolet-Visible spectroscopy(UV-visible),Fourier transform Raman spectroscopy(FT-Raman),and nuclear magnetic resonance spectroscopy(1H NMR) were used to study the oxidation of spruce lignin by chloride dioxide.
采用傅里叶变换红外光谱(FTIR)、紫外-可见光谱(UV-visible)、傅里叶变换拉曼光谱(FT-Raman)以及核磁共振(1H NMR)分析技术对云杉木质素被二氧化氯氧化前后的结构变化进行了研究。
5) infrared spectrum
红外
1.
The infrared spectrum, ultraviolet spectrum, mass spectrum, 1[KG-*3]H- 1[KG-*3]H correlated spectroscopy( 1[KG-*3]H- 1[KG-*3]H COSY), ( 1[KG-*3]H detected) heteronuclear multiple-quantum coherence(HMQC), ( 1[KG-*3]H detected) heteronuclear multiple-bond coherence(HMBC) of simvastatin were reported and interpreted.
对辛伐他汀的红外(IR)、紫外(UV)、质谱(MS)、氢氢相关谱(1H1HCOSY)、碳谱(13CNMR,DEPT)、碳氢相关谱(HMQC)、碳氢远程相关谱(HMBC)予以解析并进行了报道,对所有的1HNMR和13CNMR谱信号进行了归属;讨论了红外特征吸收峰所对应的官能团的振动形式,并且对样品进行热差和热重分析,显示该样品为单一晶型,不含结晶水。
2.
The infrared spectrum, ultraviolet spectrum, mass spectrometry, 1H- 1H correlated spectroscopy ( 1H- 1H COSY), ( 1H detected)heteronuclear multiple-quantum coherence (HMQC), ( 1H detected)heteronuclear multiple bond coherence (HMBC) of Imiquimod were reported and interpreted.
对咪喹莫特的红外 (IR)、紫外 (UV)、质谱 (MS)、氢 氢相关谱 (1 H 1 HCOSY)、碳氢相关谱 (HMQC)、碳氢远程相关谱 (HMBC)予以解析并进行了报道。
3.
The infrared spectrum,mass spectrometry,()~1H-()~1H correlated spectroscopy(~1H-()~1H COSY),(~1H detected) heteronuclear multiple-quantum coherence(HMQC),(~1H detected) heteronuclear multiple bond coherence(HMBC) of delavirdine mesylate were studied.
讨论了质谱的主要碎片离子的可能裂解方式和红外特征吸收峰所对应的官能团的振动形式,为该类化合物的结构解析提供了分析依据。
6) FT-IR
红外
1.
The structures of semifinished products were determined by FT-IR and the adsorption capacities to Ni2+ were comparatively analyzed,which validated the synthesis of P-C-CTS (Ni) in desirable processes.
通过不同吸附剂的红外光谱分析、含水率和Ni2+吸附容量的比较,验证了技术路线的正确性。
2.
,is a medicine raw material of domestic and international and tight lacking,This text expatiated the large instrument in application,with the living op- tical microscope and FT-IR spectrum and UV spectrum and fluorescence spectrum method to determined grade and con- tent of the prepared bilirubin in laboratory,and to attestation each other,and noticed the test term.
本文阐述了运用大型仪器,以生物光学显微镜、傅立叶红外光谱法、紫外分光光度法、荧光激发光谱法对实验室自制的胆红素的品位和含量进行了相互认证式测定,且注意了测试条件。
3.
12mg/g,and by FT-IRthe compositions were tested and verified.
12mg/g,并通过红外光谱测验,交叉验证提取物的成分。
参考词条
补充资料：红外线检测
红外线检测
infra-red inspection
hongwo一x一onJ一onee红外钱检测(infra一red inspeetion)采用侧t红外辐射的办法，检测构件表面温度或温度分布，以确定其运行状态或是否存在内部缺陷的无损检测技术.红外线是波长范围为0.75尸nl~100勿止m的电磁波。构件表面都辐射红外线，其功率与温度的四次方成正比。热像仪或红外辐射计接收红外线辐射后转变为与温度四次方成正比的电信号，从而可测出构件表面的温度及其分布。当构件存在缺陷时，无论其本身具有热源，或另外加热(如用电流、等离子枪、火焰喷射枪、红外灯等)、或冷却都会导致温度分布异常。从这些异常中即可探侧出缺陷部位之所在.红外线检侧的特点是可以非接触远距离进行，特别适用于探测高速旋转、高温、带高电压及对人身安全危害性大的构件和设备的退度变化情况，并可以对被检构件进行大面积普查。若被检构件在仪器视场之外或被不能透过红外线的物体遮挡时，可用红外光导纤维把红外线引出来进行探侧.红外线检测还具有准确、可靠和实时显示的特点，但用于定性探伤还存在一定局限性。 红外线检测在电力工业中主要应用于:①发电机转子分层绝缘红外检测。将红外光导纤维从通风槽插人对准转子表面，通过红外探测器和信号处理系统，可测出转子表面温度分布曲线，从而判定绝缘层的损坏程度。②发电机滑环炭刷磨损红外检验.用热像仪观测炭刷温度，判定其运行是否正常。③发电机定子汇流端接触不良红外检验。用热像仪从发电机窥视孔观侧汇流端的过热点.以确定接触不良的部位。④发电机定子铁芯红外检验是在施加励磁电流后用热像仪扫描便可得出有无局部短路的热像。⑤变电站与升压站电气设备的红外检验。高压电气设备和避雷器、电力电容器、互感器、电力电缆、高压断路器、接头、刀闸、开关、穿墙套管和变压器的瓷套管等，均可用热像仪测出其过热部位。⑥可对热力设备如锅炉炉顶、炉墙、烟道、风管、除氧器、加热器、主蒸汽管、再热蒸汽管、高压给水管、导汽管、汽缸等进行红外检验，用热像仪查找漏热并做出热损耗分析。也可对水冷壁管内壁腐蚀情况作红外检验。⑦利用直升飞机携带红外热像仪进行高压翰电线路的巡测，可有效地检测出高压输电线路中如导线压接头及瓷瓶等的缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。