1) fever type
热型
1.
Methods 202 FUO patients were chosen and their causes were categorized,the fever type and changes of fever process were observed by the curves of temperature changes.
目的分析不明原因发热(FUO)患者的病因,观察发热热型和热程变化,评价降温护理效果。
2) Fever and not fever
发热型非发热型
3) pyrolysis model
热解模型
1.
A simplified Solomon pyrolysis model for simulating HCN release in NO formation during coal combustion is proposed.
提出一种简化的Solomon热解模型 ,用于模拟煤粉燃烧NO生成数值模拟中HCN的释放 。
4) heat setting
热定型
1.
Relationship between wear behavior of PTT knitting underwear and heat setting temperature;
PTT针织内衣服用性能与热定型温度的关系
2.
Multivariable fuzzy control technology of heat setting machine;
热定型机的多变量模糊控制技术
3.
Influence of heat setting on the structure and properties of block poly(ether ester) elastic fiber;
热定型对嵌段聚醚酯弹性纤维结构与性能的影响
5) heat transfer model
传热模型
1.
Study on the heat transfer model ofheat transfer process for continuous cast slabs;
连铸板坯热送过程传热模型研究
2.
The research progress of heat transfer model of the heat exchanger for ground-source heat pump;
地源热泵埋管换热器传热模型的研究进展
3.
Laplace solution for heat transfer model of dam leakage;
大坝渗漏传热模型及拉氏变换解
6) heated-mold continuous casting
热型连铸
1.
Cu-Sn alloy wires were prepared by the "heated-mold continuous casting+cold deformation+ recrystalliza- tion annealing + cold deformation" technics.
通过"热型连铸法+冷拔+再结晶退火+冷拔"工艺制备的Cu-0。
2.
The contrast of heated-mold continuous casting of copper rod experiments on two different structural molds were carried out.
用两种结构铸型进行了热型连铸铜杆对比试验研究,结果表明,提高铸型温度梯度有利于稳定固液界面的位置,从而扩大热型连铸工艺参数配合的范围。
3.
By approprizte process parameters,the Al-1%Si alloy wire with good surface quality and unidirectional dendritic crystal was fabricated on the self-made horizontal heated-mold continuous casting equipment.
在自制的水平热型连铸设备上,采用一定的工艺参数,制备出了表面呈镜面,内部组织沿轴向定向排列的柱状晶Al-1%Si线材,其与金属型生产的多晶线材相比,屈服强度提高40%,伸长率提高35。
补充资料：鞍山钢铁(集团)公司大型轧钢厂大型轧机热轧型钢
鞍山钢铁(集团)公司大型轧钢厂大型轧机热轧型钢
鞍山钢铁(集团)公司大型轧钢厂大型轧机热轧型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条