1) Break rate
折断率
2) sperm fracture rate
精子折断率
1.
Sperm morphology wet preparation was used to eva- luate sperm motility and the sperm fracture rate.
0 1) ;含冷冻保护剂的实验组与不含冷冻保护剂的对照组比较 ,精子活动率呈显著性差异 (P <0 0 1) ,精子折断率无显著性差异 (P >0 0 5 ) ;一步冷冻和分步冷冻保存的精子之间活动率及折断率相比较 ,无显著性差异 (P >0 0 5 ) 。
3) fracture
折断
1.
Removal of fractured instruments using ultrasonic technique under microscope.;
显微超声技术在折断器械取出中的临床应用
2.
Factors associated with removal of fractured instruments from root canal;
显微超声技术处理根管内折断器械的影响因素及临床应用
4) Broken
折断
1.
Results The causes of spinal internal fixation broken were stress concentration and abnormal movement of internal fixation, and was mainly relative to poor techniques.
结果椎弓根螺钉内固定折断原因为局部应力集中及异常活动,多为技术因素。
5) break
折断
1.
Based on the calculation and analyses for the bent strength of small h ole male mould occurring the maximum bent inflection in the female die, a kind of new method of keeping small hole male mould from breaking is put forward.
通过对小孔凸模在凹模内发生弯曲变形极值情况下的弯曲强度的分析计算,提出了一种防止小孔凸模折断的新方法。
2.
In order to resolve breaking easily of usual badminton racket because of low intensity the following pursuit is done.
为解决普通羽毛球拍杆因强度低容易出现折断的现象 ,经过分析研究和大量试验 ,采用“60 3”液体渗碳工艺后直接淬火 ,再 180℃回火的热处理工艺 ,可使 Q2 35冷拉管制成的羽毛球拍杆具有较好的性能 ,使用中既不弯曲又不折断 。
6) breaking
折断
1.
Reason of unusual breaking of piston ring of marine diesel engine;
船用柴油机活塞环异常折断原因浅析
2.
The hard working environment and abnormal breaking of piston ring are introduced here,The essay analyzes the possible reason for the breaking by some examples.
简要介绍活塞环工作的恶劣环境,描述了活塞环的异常折断现象,通过一些实例来分析说明其折断的可能原因,最后给出应急处理方法,以及对日常管理和维护提出了切实可行的管理建议。
3.
In construction of deep geothermal water well under 1000m,accidents of filtering or sealing material plugging and casing or strainer breaking will ha ppened rather often.
千米以上的深水地热井施工常会出现滤水材料或上水材料蓬堵及套管滤水管折断等事故。
参考词条
补充资料：电导率(见电阻率)
电导率(见电阻率)
conductivity
d!日nd日O}已电导率(eonduetivity)见电阻率。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。