1) elastic wrapping bite guard
弹性包绕式垫
1.
Treating anterior crossbite with elastic wrapping bite guard and screa expansian mechanic in the mixed olentition;
弹性包绕式垫加螺旋扩弓器矫治替牙期后牙反
2) spiral wound gasket
缠绕式垫片
1.
Experiment investigation about joint s spiral wound gasket used on medium-pressure flange;
中压管法兰用缠绕式垫片试验研究
2.
Manufacturing process and quality control for spiral wound gaskets;
金属缠绕式垫片制造工艺及质量控制
3.
The sealing design criteria to measure the factors of spiral wound gasket were adopted, based on this bolt loads of flange can be determined by using the new PVRC method.
采用密封设计准则 ,通过试验确定了金属缠绕式垫片的垫片系数 ,在此基础上 ,按照PVRC新方法对法兰螺栓载荷进行了计算。
3) wind-on enveloped transformer
绕包式
4) wet method of taping
湿式包绕
5) elastic cushion
弹性垫
1.
Numerical analysis of the deformation of elastic cushion and its effect on the forming results in MPF of sheet metal;
多点成形中弹性垫变形及其对成形结果影响的数值分析
2.
To obtain the exact object shape, the forming surface of MPF must be corrected based on the deformation of elastic cushion.
多点成形过程中的弹性垫技术是抑制压痕的有效方法,但是弹性垫的使用对成形件的形状也有影响。
3.
The dimples can be suppressed effectively by application of the elastic cushion and the thicker the elastic cushion the better its dimple suppression effect,but thick cushion leads to large error between the shape of the obtained part and its target shape.
研究结果表明:多点拉形工艺中的压痕主要分为包络式和凹凸式两种;采用弹性垫技术能够有效抑制压痕的产生;弹性垫越厚对压痕的抑制作用越好,但是成形件与目标形状的误差也相应加大;选择适当厚度的弹性垫,可以得到表面光滑、成形误差较小的工件。
6) elastic layer
弹性垫层
1.
The basic performance and designing principle of a kind of elastic layer material, which were applied in the Roller Mill to reduce the machine noise, were introduced.
研究了作为火电厂球磨机筒内降噪弹性垫层材料的基本性能及设计原则。
2.
The impact frequency caused by steel balls in 350/700 Roller Mills on the lining plates and the innate frequency of the system consisting of “lining plate elastic layer cylinder” are calculated.
分析和计算了ＤＴＭ３５０／７００型球磨机的钢球对衬板的冲击频率和“衬板－弹性垫层－筒体”系统的固有频率，确定了磨机筒体振动响应的最大频率范围。
补充资料：绕绕
1.纠缠貌。 2.回环旋转貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条